Where is the timing pin on a cat engine?
Slowly rotate the crankshaft counterclockwise (direction of engine rotation) until the timing pin goes into the slot in the fuel injection pump camshaft. Put the timing bolt in the timing hole in the flywheel housing.
How do you set timing on a 3406b cat engine?
How do you set the timing on a 3406B CAT engine. Put the timing bolt in the timing hole in the flywheel housing. Rotate the crankshaft counterclockwise (as seen from the flywheel end of the engine) until the fuel pump camshaft is tight against timing pin (2). This removes gear clearance from the drive train.
How are timing marks aligned on a caterpillar?
Timing marks (1) and timing marks (6) are aligned in order to provide the correct relationship between the piston movement and the valve movement. Note: The rocker arm bolts must be loosened to remove preload from the camshaft. Front cover is removed.
How to fix a cam gear in a caterpillar?
Remove the cam gear backlash tool. Clean the studs with a wire brush to remove any old thread lock compound for the three nuts and washers removed in Step 2. Apply Loctite 242 to the studs. Install the 3 nuts and washers that were removed and torque to 55 ± 10 N·m (41 ± 7 lb ft).
How to install fuel injection in a Caterpillar 3208 engine?
Put the fuel injection pump housing and governor in position on the engine. Install the bolts and lines. 2. Install the tachometer drive shaft and tighten it to a torque of . 3.o check the timing, remove the T timing pin and the bolt. Turn the crankshaft (clockwise) two revolutions and install the timing pin and bolt back in place.
How to remove a fuel injection pump from a caterpillar?
Caterpillar 3208 FUEL INJECTION PUMP HOUSING AND GOVERNOR DISASSEMBLY & ASSEMBLY •Remove Fuel Injection Pump Housing & Governor TOOLS NEEDED A B 3P1544 Timing Pin 1 5P2371 Plate 1 OS1616 Bolt ¼”20 NC x 1” long 2 Start By: a) Removing the air filter b) Removing the fuel injection lines c) Removing air inlet manifold 1.