Where is the speed sensor on a 2003 Nissan Altima?
transmission housing
The speed sensor is located on the transmission housing. Follow the cable that runs along the firewall to the transmission it will terminate into the speed sensor.
What does a revolution sensor do?
Revolution sensor detects the rotation angle of crank shaft and cam shaft, and it is uses for the ignition timing control. High performance :Using high sensitivity and high output of devices, improvements of angle detection accuracy and repeatability detection are realized.
Where is the speed sensor on a Nissan Altima?
The battery in the Nissan Altima is located on the driver-side of the engine compartment in front of the air filter housing. Remove the electrical connector from the speed sensor located on the driver-side of the transmission near the firewall.
Where is the battery located in a Nissan Altima?
Disconnect the negative battery cable from the battery using a 10 mm wrench to loosen the cable end and then twist as you pull the cable off the battery. The battery in the Nissan Altima is located on the driver-side of the engine compartment in front of the air filter housing.
How do you install a sensor in a transmission?
Insert the new sensor into the transmission and push it down as you twist it until it seats completely in the transmission. Rotate the sensor to line up the mounting hole and install the 10 mm bolt. Tighten the bolt securely and plug the electrical connector into the new sensor.
The battery in the Nissan Altima is located on the driver-side of the engine compartment in front of the air filter housing. Remove the electrical connector from the speed sensor located on the driver-side of the transmission near the firewall.
Disconnect the negative battery cable from the battery using a 10 mm wrench to loosen the cable end and then twist as you pull the cable off the battery. The battery in the Nissan Altima is located on the driver-side of the engine compartment in front of the air filter housing.
Where is the fuse panel on a Nissan Altima?
Use always an intact fuse of the same color. The fuse panel is located behind the lid on the driver’s side of the dashboard. Pull the fuse box cover to remove. Engine Control Module, Injectors, Immobilizer Control Unit (2001-2002), Body Control Module (BCM (2003-2006))
Where is the camshaft position sensor on a GM car?
Look around the top section of the timing belt/chain cover (in the front of the engine) or at the rear end of the cylinder head. Some GM models may have a special compartment for the sensor.