Where is the reverse gear on the RX-8?
There were 6 different transmissions offered with the RX-8 worldwide that I am aware of, 3 automatics and 3 manuals. This is the most common of all the transmissions, being paired with the Series1 6-port engine. Reverse is located to the right of 6th gear, and requires pushing down on the shift knob to enable the shifter to enter the reverse gate.
What kind of transmission does a 1993 RX-8 have?
This is the R15M transmission used in the 1993+ RX-8. It was only available with the RX-8 outside of North America, and was usually paired with a 4-port engine. 1st – 3.483 2nd – 2.015
What kind of noises do you hear when you shift gears?
Use some fast acceleration, allowing the transmission to firmly shift. Listen for any rumbling, growling or mechanical metal-to-to metal noise in each gear just after it shifts. Such noises indicate problems with the individual planetary gears, input shaft or interior transmission bearings.
How does a solenoid get power to shift gears?
The transmission control module (TCM) — the brains of the transmission — will send power to one of the shift solenoids in order to shift gears. Inside the solenoid, there’s a plunger surrounded by a magnetic coil.
What should I do if my transmission is slipping?
After adding the fluid, I suggest that while the car is running, you move the shift lever through the different gears on the shifter selector, and then check the fluid again. Running the shifter through the gears redirects the fluid to different parts of the transmission and removes the air pockets.
What causes a car to slip in the gears?
These are the most common causes of transmission slippage: Get it diagnosed by a professional Low fluid level: Automatic transmissions depend on pressurized hydraulic fluid. A low fluid level can result in lack of pressure, preventing the gears from engaging like they should. This often results in transmission slippage.