Where is the power steering fluid container?
The reservoir that holds your power steering fluid can be found under the hood. It is usually located at the passenger’s side of the vehicle, where the belts in a smaller or transverse-mount engine are located, but you will also sometimes find the reservoir on the driver’s side.
Is it better to check power steering fluid hot or cold?
Power steering fluid expands some when it becomes hot so the fluid level will change. If the vehicle has not been driven for at least 8 hours, use the cold reading. Otherwise, use the hot level reading. If the fluid level is at the add mark or lower, there may be a leak.
Where is the power steering fluid reservoir located?
Pop the hood and locate the power steering fluid reservoir. Some reservoirs are right above or next to the power steering pump while systems feature “remote reservoirs” located in a different position in the engine bay. Clean off the reservoir cap and remove it. Most caps will have small dipsticks with indicators of appropriate levels.
What happens if you over fill power steering fluid?
There are too many different types of fluid, and if the wrong fluid is used, it may cause failure of power steering and its seals. Be careful not to overfill your power-steering unit with fluid. It’s probably better to under fill your unit than overfill it. That’s because power-steering fluid expands as it heats up and works its magic.
Why do I need a bigger power steering reservoir?
High performance vehicles often require a larger reservoir of power steering fluid. If you’re running a higher-flowing power steering pump, the larger power steering reservoir tank will ensure that there’s always fluid available. Summit Racing also carries hoses and lines for your higher-pressure steering system.
When to check your power steering fluid level?
Note: Some vehicles have hot and cold level markings. Power steering fluid expands some when it becomes hot so the fluid level will change. If the vehicle has not been driven for at least 8 hours, use the cold reading. Otherwise, use the hot level reading.