Where is the intermittent wiper control located on a car?
A partial or complete loss of intermittent wiper control. To fix these two problems, you’ll need a shop manual, a digital multimeter and possibly some Torx bits. On most late-model vehicles, the MFS is located under the plastic covers behind the steering wheel.
What kind of car is the Mercedes ML350 BlueTEC?
Car is 2010 Mercedes ML350 bluetec. Check engine light came up and we have checked and the code was U029D lost communication with NOx sensor A and U029E lost communication with NOx sensor B. Also P20BD redurtant heather “B” control circuit open.
What to do if intermittent wiper is not working?
If the problem is faulty intermittent wiper operation, use a multimeter to check the connectors on the back of the MFS for resistance (ohms) readings for each setting on the intermittent wiper dial. Then compare them with the manual. If the resistance readings are off, the shop manual will tell you to replace the MFS.
Why are my wipers not working on my Mercedes?
It is common for the fuse to burn out if you press the window switch to active the wipers, but the wipers have frozen, or there is snow on the windshield. Replacing the fuse may be all that you need to do to fix the wiper problem on your Mercedes-Benz.
What should I use to lubricate my Mercedes wiper?
-a slow wiper movement as the wiper moves on the windshield. You should lubricate the wiper mechanism at the center (bottom) of the windscreen. Remove the cover from the wiper arm and use a lithium grease such as Liquid Wrench White Lithium Grease. Here is a helpful tutorial on how to lubricate windshield wiper mechanism on a Mercedes-Benz.
What to do if your windshield wiper is not working?
Make sure that the link between the wipers and the wiper motor is not broken. Next, try tightening the bolt that holds the wiper arm in place. It is possible that there is a problem with the controller area network or the front signal acquisition module (SAM).
Where is the plug for the windshield wiper motor?
If you are not getting power to the plug that goes into the windshield wiper motor, then you need to do some further troubleshooting. The next item to inspect would be the windshield wiper switch or what is also called the combination switch. The combination switch is located in the steering column.