Where is the drain plug on a Nissan Altima?
Place a bucket or tray with at least a 2-gallon capacity underneath the radiator and below the drain plug. The drain plug on a Nissan Altima is on the passenger side bottom of the radiator.
How can I flush the radiator in my Nissan Altima?
Refill the radiator to within an inch of it overflowing. Check the drain plug and hoses for any possible leaks. Start the Nissan Altima and turn the heater to the high setting. Let it run for about 10 minutes and shut the engine off. Check the coolant level and refill, if necessary. Finally, put the radiator cap on and close the hood.
How do you remove the radiator drain cap?
Open the radiator drain plug at the bottom of the radiator and remove the radiator filler cap. This is the only step required when partially draining the cooling system (radiator only). • Do not allow the coolant to contact the drive belts. • Perform this step when engine is cold. 3. Follow this step for heater core removal/replacement only.
How do I drain coolant from my car?
2. Open the radiator drain plug at the bottom of the radiator and remove the radiator filler cap. This is the only step required when partially draining the cooling system (radiator only). • Do not allow the coolant to contact the drive belts. • Perform this step when engine is cold.
Place a bucket or tray with at least a 2-gallon capacity underneath the radiator and below the drain plug. The drain plug on a Nissan Altima is on the passenger side bottom of the radiator.
What to do if radiator in Nissan Altima overflows?
Refill the radiator to within an inch of it overflowing. Check the drain plug and hoses for any possible leaks. Start the Nissan Altima and turn the heater to the high setting. Let it run for about 10 minutes and shut the engine off. Check the coolant level and refill, if necessary.
Where do you drain the coolant in a Nissan?
Thanks! Click to expand… if you are just doing your radiator u dont need to touch the block. but if you want to do a FULL drain and REFILL you gotta drain the block too. according to the FSM the plug is high up and on the side of the block under the intake manifold. might not be easy to get to. 1. Remove the engine under cover.
Open the radiator drain plug at the bottom of the radiator and remove the radiator filler cap. This is the only step required when partially draining the cooling system (radiator only). • Do not allow the coolant to contact the drive belts. • Perform this step when engine is cold. 3. Follow this step for heater core removal/replacement only.