Where is the door lock on a GMC Yukon?
The only area of the door inner that I haven’t searched visually is where the door latch mechanism is bolted to the door fenderwell panel. This is because it is not possible to see in there due to metal concealing that area. Before I blindly unscrew the door latching mechanism, two questions: 1) is that were the door lock actuator is located?
What should the BCM be on a GMC Yukon?
The meter should read low, like 0 to 2 ohms when the door is closed, but infinite resistance when the door is open. If this is the case, it is not the rear hatch switch, it’s a bad BCM. If the resistance doesn’t change, then it is the door switch, which is either stuck open or closed.
Where is the ajar switch on a GMC Yukon?
This was from a posting on a different site: “The ‘Door Ajar’ switches are located on the latches inside the door. the most common failure in this system is the micro-switch on the latch. on most models you can replace the door lock actuator (ajar switch is part of this actuator) and the issue should be resolved.
Where are the hanger hooks on a GMC Yukon?
One is at the leading edge of the bottom of the panel. The other is just forward of the door pull. The door inner trim panel has several very sturdy molded hanger hooks on its backside. These fit into openings in the door inner metal and when the trim piece is pushed downward, grip onto the door metal.
Who is the owner of the GMC Yukon?
GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Truck Emblem and the name YUKON are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed.
Where is the tilt button on a GMC Yukon?
Manual Cushion Tilt (If Equipped) If your vehicle has this feature, you can raise or lower the front of the driver’s or passenger’s seat with this lever located at the inside edge of the seat. To raise or lower the front of the seat, move the lever up or down in a continuous motion until the cushion reaches the desired height.
Where is the power lumbar control on a GMC Yukon?
1-5 Power Lumbar Control (If Equipped) If your vehicle has this feature, the four-way control is located on the outboard side of the seat. To increase or decrease support, press and hold the front or rear of the control. Let go of the control when the lower seatback reaches the desired level of support.
Is the GMC Yukon XL a registered trademark?
2002 GMC Yukon/Yukon XL Owner’s Manual Litho in U.S.A. Copyright General Motors Corporation 6/18/01 Part Number X2216 A First Edition All Rights Reserved ii GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Truck Emblem and the name YUKON are registered trademarks of General Motors Corporation.
The only area of the door inner that I haven’t searched visually is where the door latch mechanism is bolted to the door fenderwell panel. This is because it is not possible to see in there due to metal concealing that area. Before I blindly unscrew the door latching mechanism, two questions: 1) is that were the door lock actuator is located?
One is at the leading edge of the bottom of the panel. The other is just forward of the door pull. The door inner trim panel has several very sturdy molded hanger hooks on its backside. These fit into openings in the door inner metal and when the trim piece is pushed downward, grip onto the door metal.
This was from a posting on a different site: “The ‘Door Ajar’ switches are located on the latches inside the door. the most common failure in this system is the micro-switch on the latch. on most models you can replace the door lock actuator (ajar switch is part of this actuator) and the issue should be resolved.
The meter should read low, like 0 to 2 ohms when the door is closed, but infinite resistance when the door is open. If this is the case, it is not the rear hatch switch, it’s a bad BCM. If the resistance doesn’t change, then it is the door switch, which is either stuck open or closed.
Are there any power gauges on my Yukon XL?
My 2003 Yukon XL (Suburban) with 5.3 motor and 70k miles has no power to any of dash gauges. The truck runs and operates fine, but the radio, heater controls and dash lights work fine. No gauge activity at all. All gauges are at the zero mark. I believe I have checked all fuses at left hand corner of dash, under dash and the under hood fuse box.
What kind of power does a 2003 Yukon XL have?
My 2003 Yukon XL (Suburban) with 5.3 motor and 70k miles has no power to any of dash gauges. The truck runs and operates fine, but the radio, heater controls and dash lights work fine. No gauge activity at all. All gauges are at the zero mark.
Why does my dome light not come on when I leave the door open?
If the dome lights aren’t working in either position, check your fuses. Probably a bad door switch. To keep the battery from draining, the light control is designed to kill the dome light if you leave the door open.
Why are the dome lights not working on my Chevy Silverado?
My dome lights work, but the doors when opened will not operate these lights. Make sure your dome lights switch is set on door, it could just set for off. 75 people found this helpful. It could be a short or bad switch. Check to make sure the switch on the dash that controls the light brightness is not cut off.
If the dome lights aren’t working in either position, check your fuses. Probably a bad door switch. To keep the battery from draining, the light control is designed to kill the dome light if you leave the door open.
My dome lights work, but the doors when opened will not operate these lights. Make sure your dome lights switch is set on door, it could just set for off. 75 people found this helpful. It could be a short or bad switch. Check to make sure the switch on the dash that controls the light brightness is not cut off.
Why is rear access open light on when door is open?
@louis1 there are some sensor in the latch assembly that could register your access as being open. It’s a pretty involved task so try to reset your computer first. Disconnect the battery cable and for a few minutes keep holding the battery cables together.
How to program a GMC Yukon XL garage door opener?
The GMC Yukon XL is a full-sized sport utility vehicle based on the Chevrolet Suburban. The Yukon XL is available in half ton and three quarter ton models, as well as two- or four-wheel drive. By programming the universal home remote system on your Yukon, you can eliminate your garage door opener’s hand held transmitter.
Who is the owner of the 2005 GMC Yukon?
2005 GMC Yukon/Yukon XL Owner ManualM GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Truck Emblem, and the name YUKON are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.
What kind of vehicle is the GMC Yukon?
GMC, a subsidiary of General Motors, has been making light trucks and sport utility vehicle since the early 20th century. The GMC Yukon XL is a full-sized sport utility vehicle based on the Chevrolet Suburban. The Yukon XL is available in half ton and three quarter ton models, as well as two- or four-wheel drive.
Where is the home remote on a Yukon XL?
Push down and hold the two outer buttons on the universal home remote system on your Yukon, located above the windshield on the driver’s side of the cabin. Continue to hold down the buttons until the universal home remote light starts to flash, which usually takes 20 seconds. Do not hold the buttons down for more than 30 seconds.