Where is the crankshaft position sensor located on a 2003 Honda Accord?
The crankshaft position sensor in your Honda Accord is located behind the crank trigger plate.
What does OBD code p0341 mean on Honda?
OBD2 Code P0341 Honda definition: This P0341 Honda code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal. The camshaft position sensor (CPS) sends a specific signal to the PCM for Top Dead Center on the compression stroke as well as signals indicating the position of the cam sensor.
What causes an OBDII code on a Honda?
P0341 HONDA Possible Causes 1 Faulty Camshaft Position Sensor 2 Camshaft Position Sensor harness is open or shorted 3 Camshaft Position Sensor circuit poor electrical connection 4 Faulty starter motor 5 Starting system circuit 6 Dead (Weak) battery
Why do I have a DTC p0341 engine light?
As a result, it stretches beyond the point where the cam chain auto-tensioner can keep up. That extra chain slack causes the valve timing control (VTC) actuator and the exhaust camshaft sprocket to lag behind, and you wind up with DTC P0341.
What is the OBD code for a Honda camshaft?
OBD2 Code P0341 Honda definition: This P0341 Honda code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal.
What does the p0341 Honda engine code mean?
The camshaft position sensor signal sent to the Engine Control Module(ECM) during the first few seconds of engine cranking is out of range. P0341 HONDA Possible Symptoms Engine Light ON (or Service Engine Soon Warning Light) Possible lack/loss of power Engine may stall while driving P0341 HONDA Meaning
What kind of code does a Honda Accord have?
This month, we’ll be taking a look at a 2003 four-cylinder Accord that came in with a check engine light complaint, but no reports of driveability issues. It was due for a New York state inspection, so it had to be repaired. The code was persistent, setting itself consistently on the second startup.
As a result, it stretches beyond the point where the cam chain auto-tensioner can keep up. That extra chain slack causes the valve timing control (VTC) actuator and the exhaust camshaft sprocket to lag behind, and you wind up with DTC P0341.
P0341 HONDA Possible Causes 1 Faulty Camshaft Position Sensor 2 Camshaft Position Sensor harness is open or shorted 3 Camshaft Position Sensor circuit poor electrical connection 4 Faulty starter motor 5 Starting system circuit 6 Dead (Weak) battery