Where is the CPS sensor located on a Jeep YJ?
Pretty much leaving your Jeep Wrangler or Cherokee sitting dead. Where is the CPS Sensor located? In the Jeep Wrangler YJ & Cherokee XJ, it is located inside the distributor on both the 2.5L & 4.0L. Will it trigger the check engine light if the sensor is faulty?
Where is the camshaft on a Jeep YJ?
Rotate the engine either by hand until the pulse ring enters the magnetic pick-up on the camshaft position sensor. Rotor button should be pointing at about 8:30 – 9:00 o’clock position. Turn the ignition key to the “On” position. You should be reading approximately 5 volts.
How to install a VW 5 cyl 2.5 engine cam position sensor?
Before installing a new cam sensor on your vehicle you should alway check to be sure the engine is properly timed. VW 2.5L 5 Cylinder engines use a timing chain so it is important to know this is in proper working order first. http://www.deutscheautoparts.com/View… Disclaimer: Please note all DIY are intended for basic information.
How does the camshaft position sensor work on a jeep?
Camshaft position sensor determines which cylinder is firing. Then it uses that information to sync the injectors with the ignition. The CPS is one of two sensors that if they fail, your Jeep will not fire the spark plugs or cycle the fuel injectors.
Where is the camshaft position sensor on a Jeep YJ?
Stick a screwdriver into the boot. Hold the shank of the screwdriver about 1/8″ from a ground (close to the block or near-by bracket). The tip of the spark plug that you removed the boot from would be best. Making sure the Jeep is in neutral. While they hold the brake, have a helper turn the engine over by the ignition.
What do you need to know about camshaft position sensor?
The camshaft position sensor (CMP) is just one of the many electrical parts found in a vehicle. We’ll go over what this component is, the symptoms of a bad camshaft position sensor, and what you can expect its replacement cost to be when it’s faulty.
How much does a bad camshaft sensor cost?
In this case, because of an inaccurate reading from a bad camshaft position sensor, more fuel than necessary is injected into the engine which causes your fuel economy to drop. To replace a camshaft position sensor, you can expect to pay anywhere from $120 to $300. Parts alone will run about $50 to $200.
Where is the CPS sensor located on a Jeep Wrangler?
Camshaft position sensor determines which cylinder is firing. Then it uses that information to sync the injectors with the ignition. The CPS is one of two sensors that if they fail, your Jeep will not fire the spark plugs or cycle the fuel injectors. Pretty much leaving your Jeep Wrangler or Cherokee sitting dead. Where is the CPS Sensor located?