Where is the camshaft position sensor located in the Hyundai 2012 Sonata?
It is mounted at the right hand side (looking from the front of the engine)of the cylinder head. You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable.
Where is a bad camshaft position sensor located?
A faulty camshaft position sensor should be replaced. To protect the camshaft position sensor, it’s often put in difficult to access locations like deep within the engine or between the engine and transmission. Other times it might be located conveniently near the top or front of an engine.
Can a bad camshaft sensor cause your car to stall?
Your engine stalls: An intermittent or faulty signal from the sensor can rob the engine of spark or fuel, causing it to stall. This can also result in the car’s computer going into “limp-home mode,” meaning only a couple of gears will be available, forcing you to drive relatively slowly.
Can a camshaft sensor cause a car not to have spark?
The advantages to such a system include the absence of a rotor or distributor cap, which may burn or crack with use, along with the absence of a vacuum advance diaphragm, which can rupture or leak. But when a camshaft position sensor takes the place of a distributor, failure of that sensor could result in there being no spark.
What happens if the fuel sensor isn’t working?
Your engine isn’t running well: The signal from this sensor is required to operate the fuel injectors, as well as most timing-based engine functions, like spark control. Because of this, a faulty sensor can easily cause a misfire, poor acceleration or other problems.
Where are the camshaft sensors located on a Hyundai Sonata?
I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor. Was this answer helpful? elynbert will be eternally grateful.
How do you remove a camshaft position sensor?
You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2. Disconnect wire connector from sensor. 3. Remove sensor mounting bolts. 4. Remove the sensor from the rear of cylinder head. 1. Install camshaft position sensor in rear of cylinder head. 2.
Where is the intake CMP located on a Hyundai Sonata?
Intake cmp is on the front of the engine just below the valve cover almost even with the right side of the manifold. The exhaust cmp sensor is in the same location on the backside of the head. Was this answer helpful? I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor.
Where is the camshaft position sensor on a Honda Accord?
elynbert, the camshaft position sensor monitors the position of the camshaft. It is mounted at the right hand side (looking from the front of the engine)of the cylinder head. You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2.