Where is the brake light on a Honda Civic?
Open the Honda Civic’s trunk and remove the plastic cover over the brake light housing. Unscrew the plastic tab with your hands and pull the cover off of the frame. The plastic tab has raised edges to grip with your fingers. Pull the brake light housing out of the fitting and locate the burned out brake light.
How do you replace a brake light on a Honda?
In order to replace the part, you need to create a vacuum in the braking system, which is only possible with the car running. Press the brake pedal with one hand. With the other hand, slide the brake light switch bumper up the brake pedal, feeling around for the hole where it will go.
Why are Honda car brake lights so important?
Ensuring that your Honda car brake lights are in working condition at all times is important to your safety, as well as the safety of others. These simple bulbs signal that you are intending to decelerate or stop, allowing other motorists to react and slow down in response.
Why are the brake lights on my Honda not turning off?
If you are the owner of a Honda or an Acura and find that your brake lights won’t turn off, even after removing the key, I’m happy to say the solution is usually simple and cheap. When you press down on the brake pedal, a brake pedal switch bumper on the top of the pedal assembly moves away from a plunger, activating the brake light switch.
Why is the brake light not working on my Honda?
The brake pedal may also fail to contact the switch. Many vehicles have small plastic pads, where the switch contacts the pedal, when released. If these pads break or fall out, the pedal may not push the switch enough when released. Honda, Toyota and many other vehicles use these rubber pads and have this problem.
When does the brake light switch show continuity?
Using the wiring diagram, we can determine which leads should have continuity and when. The brake-lamp portion of the switch will show continuity when the brake pedal is depressed. When we release the brake pedal, it returns to the up-position. In this position, the brake light switch changes to an open-circuit.
What to do when your third brake light is not working?
When the lower lights do not come on and only the third-brake light works, the brake-light switch may be ruled out. Again try the emergency-flashers to check for wiring, socket and lamp problems. If the flashers work, check for blown fuses as a few vehicles use separate circuits for the lower and third brake lights.
What do you need to know about brake lights?
A wiring diagram and ohmmeter are needed. The wiring diagram shows which terminals to check. With only two terminals, continuity should show in one position and an open circuit in the other. Some vehicles may have multiple switches on the brake pedal, and some switches may have more than one set of contacts.