Where is the blower motor on a 13 nissan rogue?
Compatible Replacement for Nissan Vehicles – 2008 – 2013 Rogue | 2014 – 2015 Rogue Select | 2007 – 2012 Sentra |. The blower motor can be located behind the dashboard where the AC controls are and can be accessed easier through the driver side by removing parts underneath the steering wheel.
How to remove the blower motor on a Nissan Rogue?
Disconnect the harness connector from the blower motor. Remove blower motor screw (B). Release hook (A) then rotate the blower motor (1) counterclockwise and remove. Installation is in the reverse order of removal.
How to check for a blown fuse on a rogue?
Blown Fuse Check 2008-2013 Nissan Rogue – 2009 Nissan Rogue S 2.5L 4 Cyl. This video shows how to check for blown fuses in the engine bay of your 2009 Nissan Rogue S 2.5L 4 Cyl..
How does the temperature sensor work on a Nissan Rogue?
In-vehicle sensor measures temperature of intake air that flows through aspirator to passenger room. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.
How to diagnose a / C switch assembly in Nissan Rogue?
Diagnosis of the A/C switch assembly can be performed using the CONSULT. There is no selfdiagnostic feature available. The variable blower control controls the speed of the blower motor by controlling the ground circuit of the blower motor.
What happens when blower motor is activated on Nissan Rogue?
When blower motor is activated, A/C auto amp. gradually increases duty ratio of blower motor control signal to prevent a sudden increase in discharge air flow. It takes approximately 8 seconds for air flow to reach HI from LOW.
How does temperature correction work on Nissan Rogue?
Correction is applied to the target temperature that is set using temperature control dial, according to ambient temperature detected by ambient sensor. Passenger room temperature detected by in-vehicle sensor is corrected for each front air conditioning control (driver side and passenger side).
Diagnosis of the A/C switch assembly can be performed using the CONSULT. There is no selfdiagnostic feature available. The variable blower control controls the speed of the blower motor by controlling the ground circuit of the blower motor.
How does the air conditioner work in a Nissan Rogue?
A/C auto amp. A/C auto amp. controls front automatic air conditioning system by inputting and calculating signals from each sensor and each switch. The air mix door controls the mix of hot or cold air that enters the ventilation system. It is controlled by the A/C auto amp. based on the position of the temperature dial.