Where is purge control solenoid valve in Kia Optima?
The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal.
How does evaporative emission work in a Kia Optima?
The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold.
What are the systems in a Kia Optima?
This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way valve (pressure/vacuum relief), fuel liquid/vapor separator which is installed beside the filler pipe, charcoal canister which is mounted under the rear floor LH side member and protector, tubes and miscellaneous connections.
What are the components of a Kia Optima?
A/C Pressure Transducer (APT) 21. Purge Control Solenoid Valve (PCSV) 23. CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] 24. Electric Waste Gate Actuator (EWGA) 25. RCV Control Solenoid Valve 26. Fuel Pressure Regulator Valve 27. Canister Close Valve (CCV) 28. Ignition Coil 29. Main Relay 30. Fuel Pump Relay 31. Data Link Connector (DLC) [16-Pin]
What is the repair manual for a Kia Optima?
► ► BEST ◄ ◄ 2001 2002 2003 2004 2005 KIA OPTIMA Service / Repair / WORKSHOP Manual – (COMPLETE & EXHAUSTIVE) – PDF DOWNLOAD (YEAR 01 02 03 04 05 06 ) !! ► ► BEST ◄ ◄ 2001 2002 2003 2004 2005 KIA OPTIMA Service / Repair / WORKSHOP Manual – (COMPLETE & EXHAUSTIVE) – PDF DOWNLOAD (YEAR 01 02 03 04 05 06 ) !!
The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal.
The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold.
Where is the purge control solenoid valve located?
The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal. To draw the absorbed vapor into the intake manifold, the ECM/PCM will open the PCSV, otherwise the passage remains closed. Fuel Filler Cap
The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal. To draw the absorbed vapor into the intake manifold, the ECM/PCM will open the PCSV, otherwise the passage remains closed. Fuel Filler Cap
This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way valve (pressure/vacuum relief), fuel liquid/vapor separator which is installed beside the filler pipe, charcoal canister which is mounted under the rear floor LH side member and protector, tubes and miscellaneous connections.