Where does the muffler go on an Elite Scooter?
The muffler attaches to your Elite’s exhaust system by a clip fastener and three bolts at the base of the muffler. Unclip the fastener and unscrew the bolts to remove the muffler. Install a windshield or wind guard to the front of your scooter to alleviate wind resistance and drag.
How do you derestrict a Honda Elite Scooter?
Remove the restricting washer from the variator system to derestrict your Elite. Unscrew the perimeter bolts and then detach the front pulley wheel to open up the variator system. Under this wheel, you will see a small washer that restricts your Elite’s drive belt. Pull this washer off and put your variator back together to derestrict your scooter.
Is it better to run a race car without a muffler?
As far as the car itself is concerned it’s actually better. The exhaust is less restricted which means that your engine will perform more efficiently. That’s why race cars run straight pipes (no mufflers). However, it will be louder so you have to consider if getting ticketed is worth the risk.
Can you change the muffler on an Eite scooter?
Swap out your scooter’s muffler to eliminate excess fume buildup in your engine. Either remove your Eite’s muffler altogether or replace it with a more efficient muffler from a scooter and motorcycle retailer. The muffler attaches to your Elite’s exhaust system by a clip fastener and three bolts at the base of the muffler.
Is the Honda Elite’s the same as the sa50?
This naming created a little bit of confusion, as the 1987 Honda Elite S (SE50) also used this name, despite being an entirely different scooter (and not restricted speed). When it was introduced, the SA50 was an entirely new machine except for the motor, front suspension, rims and a few other tiny bits.
Is the Honda Elite’s a restricted speed scooter?
For 1994 Honda switched the motor to a newer design and at the same time added a restricted speed version called the Elite S (model code SA50P, P = moped legal). This naming created a little bit of confusion, as the 1987 Honda Elite S (SE50) also used this name, despite being an entirely different scooter (and not restricted speed).
How can I get rid of the exhaust restriction on my scooter?
The exhaust restriction is applied to most scooters and can be easily removed. All that is needed is a little grinder (ideally Dremel, Proxxon, or other micro grinders). Most stock exhaust feature a dummy pipe on the exhaust manifold whereas restricted after market exhausts have a little diameter restriction welded into the down pipe.
What’s the fuel milage on a Honda Elite?
Fuel milage is typically for a 50cc 2-stroke at 65-75mpg. While the core engine is the same between the ’94 – ‘01 Elite SR and the Canadian Dio the airbox, carb and mufflers were all different so be careful when buying parts.