Where does the Jaguar XJ6 series come from?
T his production cronology has been adapted from information contained in Jaguar XJ-Series (Classics in Colour 2) by Martin Buckley and James Mann ISBN 1 87200 481 4, and published by Windrow & Greene Ltd. Jaguar XJ6 (Series I) is introduced to the Earls Court Motor Show.
Is it possible to restore a 1972 Jaguar XJ6?
A car that was once fairly common and is easily identified by great swaths of the American public, yet today is rarely restored. But another contradiction is more inherent to Mike Zavos’s remarkably restored 1972 Jaguar XJ6. Yes, an early XJ6, returned to as-new (or better) quality by its owner.
What’s the rev limit on a JAG XJ-S?
The same basic principals apply to both XJ-S and XJ6/12 cars. First up which car to go for. The V12 in 5.3 form is fantastic on the race track with a 6500rpm rev limit and over 300bhp readily available, although the standard cooling system is dire.
When did Jaguar stop making the Jaguar XJ?
Build quality of the XJ varied greatly over these years, from good in the early years, to very poor during and after the British-Leyland take over in the seventies thru early eighties (approximately 1982), then back to good in the mid eighties and then very good since Ford acquired the company in 1991 until the end of Series III production in 1992.
Where are the U-joints on a Jaguar XJ6?
Then installing a cardan joint at the pinion end, that 2 degree oscillation will be carried into the rear diff. This is theoretically better than the 3 degree difference you would have if you installed conventional u-joints at both ends of the shaft.
What should the axle angle be on a Jaguar XJ6?
Most solid axle diffs in the rear have an 8 degree acceptable angle. You need to be within a + or – 2 degree angle set at 3 to keep that diff under that hot rod. Depending on the HP you should be good to go.
What kind of drive shaft does a XJ6 have?
Jaguar XJ6: 1973 Jaguar IRS installation in a street rod. Have… 1973 Jaguar IRS installation in… 1973 Jaguar IRS installation in a street rod. Have drive shaft angle questions. Submitted: 9 years ago. Category: Jaguar Happy Holidays, my name is XXXXX XXXXX thank you for choosing justanswer.com.
What’s the best angle for a hot rod Jaguar?
You need to be within a + or – 2 degree angle set at 3 to keep that diff under that hot rod. Depending on the HP you should be good to go. If you have any more questions or need diagrams or service info, please don’t hesisitate to ask. If this answer helped you, please click ACCEPT.