Where do the throttle cables go on a BMW?
This kit replaces the original throttle cable guide setup at the twistgrip for R1100S, R1150 models, and K1200 models. With this kit fitted, the throttle cables will exit the twistgrip downwards, rather than parallel to the bars.
What is the TPS on a BMW R1100?
It’s the square shaped black module with a connector on its bottom side. The TPS is a rheostat, or variable resistor. Connected to the throttle butterfly, it transmits an input to the Motronic based on throttle opening–anywhere from idle to wide open.
What kind of cable do I need for BMW R1150R?
Fits R1150R (09/2000 – 08/2006), R850R (09/2002 – 08/2007) Show All… Please note You will need part CAA91990 (if not already installed) in order to fit this cable. Very occasionally, we have used examples – please see CAT92490 . Alternatively, please see CAT59686 for a good, used, pre modification alternative.
What are the co values on a BMW R1100?
CO values on the special version with three-way catalytic converter are performed by the oxygen sensor. The things to remember here are that the most important Motronic inputs are 1) engine speed, 2) TDC (top dead center, for ignition timing reference) and, 3) throttle opening position.
How does the throttle work on a BMW R1100?
When you twist the R1100 throttle, the cable actuates a cam plate on the left throttle body, and then crosses over unbroken to the right throttle body.
This kit replaces the original throttle cable guide setup at the twistgrip for R1100S, R1150 models, and K1200 models. With this kit fitted, the throttle cables will exit the twistgrip downwards, rather than parallel to the bars.
Where is the throttle adjuster on a BMW?
Then loosen the locknut on the cable adjuster on top of the right-side throttle body cable, because this is where you will make the part-throttle adjustment. There is no need to fiddle with the cable adjuster on the left-hand throttle body for this procedure.
It’s the square shaped black module with a connector on its bottom side. The TPS is a rheostat, or variable resistor. Connected to the throttle butterfly, it transmits an input to the Motronic based on throttle opening–anywhere from idle to wide open.