Where are the yellow connectors for the airbags?
This turns off the warning light on the dash. The yellow connector is for the side impact airbag inflator located in the outer seatback side bolster. These wires are carefully protected and colored yellow to let all who see then to work with caution. Do not touch this system without understanding and following all the manufactures cautions.
Where are the yellow connectors on a car seat?
The yellow connector is for the side impact airbag inflator located in the outer seatback side bolster. These wires are carefully protected and colored yellow to let all who see then to work with caution. Do not touch this system without understanding and following all the manufactures cautions.
Why is the airbag light on in my minivan?
The airbag lamp shone. The cause was the yellow 4-pin connector under the driver seat. He has poor connections. Two pins of the plug go to belt buckle from the seat belt and two pins go to the belt tensioner. When a cable is disconnected or has a high resistance, then the airbag lamp turns on. I have cleaned the contacts.
Where are the access pins on a CAN bus?
Access can be made at the OBD connector pins 6 (CAN_H) and 14 (CAN_L). Ensure all the power is off the vehicle and connect an ohmmeter to pins 6 and 14. Here you should read approximately 60 ohms – this is the equivalent of two 120 ohm resistors in parallel.
What kind of wire to replace front airbag sensor?
REPLACEMENT OF REPAIR WIRE FOR FRONT AIRBAG SENSOR Repair wire with two pressure–contact sleeves (Part No. 82988–50010) has been prepared for exclusive use in repair– ing connector damage etc. caused by frontal collision of the vehicle. When repairing the front airbag sensor connector on the wire harness side, always use the special repair wire.
Is there an air bag clock spring wire?
GSKMOTOR 2PCS Airbag Clockspring Plug Air Bag Connector Clock Spring Wire Compatible with Ford (About 795 Models) Chrysler Dodge. . In stock on May 20, 2021. .
Where does the airbag light go on a minivan?
Two pins of the plug go to belt buckle from the seat belt and two pins go to the belt tensioner. When a cable is disconnected or has a high resistance, then the airbag lamp turns on. I have cleaned the contacts. The airbag lamp went out by itself. The error did not come back after that.
Is the seat belt pre-tensioner part of the air bag system?
The seat belt pre-tensioner is actually part of the air bag system, it can not be engaged unless the air bag deploys at the same time (or very, very close to same time). You MAY want to do a little reading on this subject before you put your foot in my mouth any further. No offence.