Where are the wires for the remote starter?
In this car it is the RED and ORANGE wires in the middle of the connector jack to the key switch. The key must be inserted to find the other 4 wires. Turning to the Accessories position, testing with my multimeter gives the YELLOW wire.
What does it mean when your remote starter wont start?
What that means to you is your remote starter probably used a data moduleas part of the installation. That allows the starter brain to communicate with the vehicle computer in its native language, because it gets programmed with vehicle-specific software. In rare instances, the module may lose its programming data and the engine won’t start.
What does 12volt mean on Hyundai remote starter?
Retard inbred Hyundai engineers uses 12volt only when the key is at the ON position. The remote start module refuses to start if the black/white safety wire is not already at 0volt. Luckily my wife has not yet gone the way of her mother by turning off her car in gear complete with keys and door wide open.
Where do I put the enormis remote starter switch?
The good news is that Enormis can fix this quickly and painlessly. ENORMIS Typically attaches these to your hood on the drivers side. If something is “dangling” from the firewall that could be the hood sensor/switch that should be attached to the hood. .
What kind of wire is a remote turn on wire?
One thing to note, most head unit wiring harnesses also have a solid blue wire. This wire is typically for power antenna or factory amplifier turn on, do not get this wire confused with the remote turn on wire with the blue/white stripe.
What’s the name of the Blue turn on wire?
The blue/white stripe remote turn on wire has a number of other names such as accessory wire, system remote control wire, etc… Some of the confusion about this wire may come from the different wiring methods between a factory and an aftermarket head unit.
How do you splice a remote turn on wire?
Since the factory wire is already terminated on both ends, splicing into the wire is necessary. Use a T-tap connector or cut the factory wire to splice into the wire by twisting the remote turn on wire together with one end of the factory wire, then crimp on a butt connector.
How do I start my car with Staub remote?
START vehicle for 15 seconds. Press and hold the brake pedal. Press and release the moduleÕs programming button. (OR if the remotes are already programmed to the vehicle, press and hold the start button of the remote for 2.5 seconds.) Wait, LED 2 will ß ash GREEN. (See the Module Diagnostics page) Release the brake pedal.