Where are the line ports on a gas tank?
When looking at my tank, it has 4 line ports. The inlet port is on top of the tank. There is one on the drivers side pointing forward that I assume is for the charcoal canister. And there are 2 pointing forward on the passenger side of the tank.
How big should a fuel line be for a furnace?
Figures 12-17 through 12-20 illustrate four ways to locate oil supply tanks. When installing a fuel tank, the following suggestions should prove helpful: 1. The filler pipe should be a minimum of 2 inches in diameter; the vent pipe 11⁄4 inches. 2. Use wrought-iron pipe with malleable-iron fittings for both the filler and vent pipes.
Where does the fuel line go in a weed eater?
Pull out about 1″ of fuel line from the fuel cap opening and attach filter. Replace the line back into the tank just like that because you want the fuel filter/line to flop around inside the tank. Now that same line goes from the tank to the bottom connector on the carb.
Do you need a return line for a gas tank?
The two line tanks dont have the return line. You dont generally need to run a return line if youre running a mechanical pump. You do need one (highly recommmended?) if you have an electrical pump. You must vent your tank in some way or you will have fuel delivery problems.
Where is the vent line on a fuel tank?
When installing a vent hose, avoid sags — aka traps — anywhere in the vent line. As I found out the hard way, these allow fuel to puddle, preventing the marine fuel tank vent system from functioning properly. A typical vent line will run sideways across the top of the tank until it reaches the hull side and then angle upward to the vent fitting.
When looking at my tank, it has 4 line ports. The inlet port is on top of the tank. There is one on the drivers side pointing forward that I assume is for the charcoal canister. And there are 2 pointing forward on the passenger side of the tank.
Figures 12-17 through 12-20 illustrate four ways to locate oil supply tanks. When installing a fuel tank, the following suggestions should prove helpful: 1. The filler pipe should be a minimum of 2 inches in diameter; the vent pipe 11⁄4 inches. 2. Use wrought-iron pipe with malleable-iron fittings for both the filler and vent pipes.
Pull out about 1″ of fuel line from the fuel cap opening and attach filter. Replace the line back into the tank just like that because you want the fuel filter/line to flop around inside the tank. Now that same line goes from the tank to the bottom connector on the carb.