Where are the fuses in the dash panel?
The fuses are located on the bottom left of the dash panel behind a cover. Replacing fuses › Remove the cover of the fuse box in the direction of the arrow. › Remove the plastic clip from the holder in the fuse box cover in the dash panel. › Place the clip on the respective fuse and pull this fuse out. › Insert a new fuse.
How can I tell if my power supply is defective?
Step 3 If the trouble is on all ports, the PoE section of the power supply might be defective if the switch works normally except for PoE and if non-PoE devices can establish an Ethernet link on any port. If the trouble is on a consecutive group of ports but not all ports, there could be a defective PoE subsection in the switch.
What to do when you need to replace a fuse in a Skoda?
Switch off the ignition and the corresponding power consuming device before replacing a fuse. Find out which fuse belongs to the component that is not operating. ■ We recommend always carrying replacement fuses in the vehicle. A box of replacement fuses can be purchased from ŠKODA Original Accessories.
Where are the fuses in a Volkswagen CC?
Fuses and relay Volkswagen CC Fuse AMPS Circuits Protected 1 10A Rear window roller blind switch Rear win 2 5A TCS/ESP button Auto-hold button ABS cont 3 5A Light switch Brake pedal switch Oil leve 4 5A Damping control unit Trailer detection c
Why is there no power to the OBD port?
Check the 15A “CIG” fuse under the hood, that is what powers the DLC, if that fuse is not blown then you have a very od problem, wiring problem maybe If I recall correctly you need to check fuse 41 under the hood. As stated earlier the accessory outlets are on a different circuit from the cig lighter which also powers your OBD port.
Can a car fuse go bad for no reason?
Even a fuse dedicated solely to the car’s computer diagnostics can blow for no apparent reason. Check your fuses to see if any have gone bad. Remember that your car or truck might have more than one fuse box. This should be covered in your owner’s manual or a proper service manual.
Is there a cig plug for the obd11?
The cigaratte lighter fuse powers the OBD11 plug. There is only one cig lighter plug. The other outlets are accessories plugs and work with the key off. The cig plug only works with the key on. Make sure a prong is not bent and not making connection. Most people assume because an accessory plug works the cig plug works too, not true.
Why is my scan port not working on my car?
Remember that your car or truck might have more than one fuse box. This should be covered in your owner’s manual or a proper service manual. Another reason for getting no reading is that the scan port has become clogged with dust after years of not being used.