Where are the brake lights on a Freightliner M2 106?
Located on the frame crossmember just forward of the rear axle. When looking at it, it will be the switch to the right (driver side) of the cluster, have air lines in and out and a 6 pin harness going into it. Please save yourself expensive repair bills and time to trace wires, locate fuses/relays, multiplexing… yada yada.
Why is my rear brake light not working?
The rear brake light and turn signal is not working on the driver side. I have replaced the bulbs and the connectors but to no avail. I checked the fuses and they are fine as well. When I take my electronic key and unlock the truck the driver rear lights will not light up but when I lock the doors it does light up in the back.
Where is the brake light valve / switch on an m2 business?
I have a 2006 M2 business class. The brake lights flicker when brake is lightly applied, lights are fine when brake is fully applied. VIN # XXXXX Is the problem in the AMU?
Is there a problem with my Freightliner M2?
Have problem with rear only I have a 2007 Freightliner M2. Have problem with rear only turn signals, brake lights, and hazard lights. When I activate left and right turn signals, the indicators on the dash work fine, and the fro… read more Daniel Wilson Auto Mechanics 1&2/diesel mech 12,785 satisfied customers
Where is the PDM on a Freightliner M2?
The fuse panel is located below and to . The main fuse box, also known as the power distribution module, or PDM, is located under the hood onthe left front fender just forward of the bulkhead module. View and Download Freightliner BUSINESS CLASS M2 driver manual online.
Where is the fuse box on a Freightliner M2?
The main fuse box, also known as the power distribution module, or PDM, is located under the hood onthe left front fender just forward of the bulkhead module. View and Download Freightliner BUSINESS CLASS M2 driver manual online.
Why are the brake lights on my Freightliner not working?
Brake lights not working narrowed it down to the AMU. Problem fixed got home doing a walk around on the truck and noticed something hanging a couple of inches from the driveshaft. Turns out it was the complete block where the AMU sensor is located with all the air lines.
Which is the M2 truck with the slowest wipers?
Convenience Feature: Wipers –Automatic Slowest Wiper Speed w/Park Brake Data Codes: 660-025: Single Electric Windshield wiper motor with delay –Programmed to slowest speed with park brake set Models: M2 Platform Vocational Sales Daimler Trucks 1177 Availability: October 2010 What
Are there any recalls on Freightliner Custom cabs?
Daimler Trucks North America is recalling eight years of Freightliner Custom Chassis Cabs because a bolt issue could disable the brake lights and lead to a crash. If the bolt, called a clevis pin, rubs or bends on the mount holding the brake pedal, the bolt could detach. That would cause the brake lights to stop working.
How do you get a service brake light on a m2?
1. Shut down the engine and chock the tires. 2. Drain the air system. 3. Install the stop lamp switch in the tee fitting. SeeFig. 1. 4. Cut the 1/4-inch air line that runs from the double check-valve between the primary and secondary service supply to the AMU in an easily accessible place under the hood. 5.
What is the problem with my frieghtliner m2?
If this is true, it could be a problem with the signal to the trans. from the shifter, or it could be a configuration problem in the trans. software, coniguration problem in the freightliner software, or a chassis module failure. Apply at the below link to get access to your specific wiring diagrams and parts and service info.
How can I troubleshoot my air brake system?
AIR BRAKE SYSTEM TROUBLESHOOTING 1.) Before replacing any valve with a new or remanufactured valve, be sure to blow the air lines out either using the vehicle’s own air supply or shop air. Dirt is the greatest cause of premature air valve failure. 2.) If pipe dope is used on fittings, use it sparingly.
What’s the problem with the brake lights on a Freightliner?
The grounds on the brake lights and other lights in back corrode and loose connection. Check the connections by removing the light assembly. The grounds just fall off. 13 yrs. of hwy. not the harness but a simple loss of ground.
Where are the brake diodes located on a Freightliner?
Freightliner dealer said no, need to buy the kit. Of course they would, lol. I believe the diodes are located at the base of the steering column? I don’t know why you would have diodes in the brake circuit, and if you did it is unlikely they all have opened circuited. Fuses are used to prevent those problems.
Why do the brake lights stay on after removing the Air Line?
If air is heard exhausting and the brake lights turn off when removing the air line, then air is being trapped in the circuit, causing the lights to stay on. This usually indicates an air line is pinched or kinked. Go to step 9. If the brake lights turn off after removing the air line, go to the next step. 8.
Is there a way to turn on each brake light?
There is no way to activate the input from the brake switch circuit but I can activate the output and turn on each brake light individually. The brake switch input into the chassis control always says the brake pedal is released even while stepping on the brake.
What does it mean when your brake lights stay on?
If the brake lights illuminate then there may be a pinched/kinked line in the steering axle circuit. If the brake lights stay on or turn off slowly, there may be a pinched line in the drive axle cir- cuit. Connect the red line and disconnect the green line and repeat to verify.
What is the engine protect light on a 2005 Freightliner?
2005 freightliner business class m2. Engine protect light 2005 freightliner business class m2. Engine protect light comes on over the road and goes out only over the road. Only code in ecm is clutch … read more