When to replace spark plugs in Honda Accord?
The fuel injection system was professionally cleaned at ~65K miles so, I’m thinking a fuel injector issue is unlikely. I likely have either another bad coil or some other ‘wiring’ issue or, the spark plug itself is becoming marginal. At ~85K miles it is time for new plugs anyway so, that took me down that rabbit hole!
Why does my Honda Accord cut out at 3200rpm?
It generally is more prevalent when cold but, also occurs after getting fully warmed up. It will ‘skip’ occasionally or continuously cut out at ~3200RPM like a LIMP Mode is kicking in. With this intermittent nature of the miss, I am a bit puzzled as to the true cause and source of the issue.
Which is the best Bosch plug for a Honda Accord?
Thanks! NGK was oem or Denso would be the best. Honda’s don’t run as good on the Bosch plugs. @ your mileage you may want to have the carbon cleaned out in the top end, try to use tier-1 gas. How did they clean the injectors ?
When to replace spark plugs in Toyota Corolla?
Plugs should always be promptly replaced per the manufacturer maintenance schedule even if they appear to be working perfectly. If your vehicle is equipped with spark plug wires (as opposed to a coil-on-plug system), the wires should be replaced at the same time. This may increase the cost of your repair.
The fuel injection system was professionally cleaned at ~65K miles so, I’m thinking a fuel injector issue is unlikely. I likely have either another bad coil or some other ‘wiring’ issue or, the spark plug itself is becoming marginal. At ~85K miles it is time for new plugs anyway so, that took me down that rabbit hole!
It generally is more prevalent when cold but, also occurs after getting fully warmed up. It will ‘skip’ occasionally or continuously cut out at ~3200RPM like a LIMP Mode is kicking in. With this intermittent nature of the miss, I am a bit puzzled as to the true cause and source of the issue.
Thanks! NGK was oem or Denso would be the best. Honda’s don’t run as good on the Bosch plugs. @ your mileage you may want to have the carbon cleaned out in the top end, try to use tier-1 gas. How did they clean the injectors ?