When to check signal strength and readability on a radio?
RADIO CHECKS, SIGNAL STRENGTH AND READABILITY Whenever using a radio for the first time or when there is doubt about its performance, the simplest check that can be done is what is known as a “radio check.” Radio checks should be carried out periodically during periods of low traffic.
Is the radio button the same as the HTML button?
And actually the normal answer won’t work (at least it didn’t for me). Your html will look pretty similar to the normal radio button: In your controller you’ll have declared the mValue that is associated with the radio buttons.
How to assign value to radio button as checked?
To have one of these radio buttons preselected, assign the $scope variable associated with the group to the desired input’s value: This makes the “second” radio button selected on loading the page. For anyone looking for an Angular2 (2.4.8) solution, since this is a generically-popular question when searching:
Can you have two radio buttons with the same name?
Note that if you have two radio button with same “name” attribute and they have “required” attribute, then adding “checked” attribute to them won’t make them checked. Example: This makes both radio button remain unchecked. This will makes the “male” radio button checked.
What are the common radio codes for out of service?
COMMON RADIO CODES Code Description 10-01 Reception is poor 10-02 Reception is good 10-03 Stop transmitting/Change channels 10-04 Message received 10-05 Relay message 10-06 Busy, (Out on call) 10-07 Out of service, Leaving air 10-08 In service/available for assignment 10-09 Repeat last transmission 10-10 Out of service – radio on
What are the 10 radio codes for kelcom?
10-Radio Codes 1 -1 Receiving Poorly 2 -2 Receiving Well 3 -3 Stop Transmitting 4 -4 Acknowledgement 5 -5 Relay 6 -6 Busy 7 -7 Out of Service 8 -8 In Service 9 -9 Repeat 10 -10 Out of Service / Subject to call
When do you need a car radio code?
A radio code is required if you have: Experienced a dead battery. Disconnected the factory radio harness. Disconnected the battery to the vehicle.
What is the radio code for Audi gamma?
Audi Gamma Factory Radio (Example code is 1462) Turn on radio and hold down the “FM1 & AM” buttons until the word “CodE” appears in display. Release buttons and 1000 appears in display. Do not touch preset #1, first digit in display corresponds to radio code. Press preset #2 – four (4) times for second digit in code.