When do you Put your bike in 1st gear?
Remove ads, support ADV. Bike stalls immediately when put into 1st gear – clutch sticking? Discussion in ‘ Thumpers ‘ started by peteandrewd, Jun 23, 2016 . Hey everyone. So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike.
Why does my Honda CVT not shift into gear?
But when the engine turns on, the vehicle still won’t shift into gear, leading to a faulty torque converter. One of the most common Honda CVT Transmission problems is the worsening of the torque converter due to leaking and burning transmission fluid.
What kind of springs go in 1st gear?
I installed the plates with the provided new springs. The only thing that was different from the OEM plates is that one of the fibre plates wasn’t as wide as the rest of them, so I put that one in first along with the judder spring. The OEM plates had a steel disc that went in 1st, with a groove in it for the judder spring to go into.
Do you need to change the gears on your bike?
We’re sorry to say, but that sounds like you may need to replace your chain, cassette and chainrings. If the gears on your bike are properly indexed, each single click of the shifter will cause a single shift up or down the gears, front or rear.
Why do my gears jump off my bike?
On some bikes, this can cause the chain to jump off the gears completely, which means you’ll have to stop and put it back on, which usually means greasy black fingers. Shift gradually, making sure the chain has engaged with each new gear before moving onto the next one.
Why does my bike stall when put into 1st gear?
So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike. Upon start up, I let the bike warm up, held clutch in and then put the bike into gear, and it immediately jumped and stalled. It keeps doing it and I can’t ride the bike. The clutch has been bled properly with 0 bubbles.
Remove ads, support ADV. Bike stalls immediately when put into 1st gear – clutch sticking? Discussion in ‘ Thumpers ‘ started by peteandrewd, Jun 23, 2016 . Hey everyone. So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike.
So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike. Upon start up, I let the bike warm up, held clutch in and then put the bike into gear, and it immediately jumped and stalled. It keeps doing it and I can’t ride the bike. The clutch has been bled properly with 0 bubbles.
Can you push a bike around in gear?
Bike is a 2011 KTM 530 EXC. With the bike shut off can you push it around in gear with the clutch pulled in? I would pull the clutch and soak the fibers. With everything pulled out check the basket for grooves or damage. UK for now. I was having the same issue. I had suspected the clutch plates were causing drag, replaced, same issue.
Why are my gears not working on my new bike?
Indexing problems can be caused by cable stretch, which is a normal part of the bedding-in process for new bikes or cables. Check that a bent or damaged rear derailleur isn’t to blame first. If it’s all good, here’s how to index or re-index your gears. A hex key to fit your derailleur cable retention bolt, usually a size 4 or 5mm