When do you need to replace a battery on a motorcycle?
Check when the battery’s expiration date is. If it’s close to or long past the expiration date, you’ll simply need to buy a new one. If a motorcycle has been sitting for years, you’ll definitely need to get a new battery; you don’t want to use one that’s been sitting dormant for years.
Why is my motorcycle not starting after years?
If you still can’t get the motorcycle to start after going through this list, there may be a few underlying issues especially if the motorcycle was sitting for a few years. It’s actually pretty common for water to get inside the engine and rust the pistons into place. It’s annoying when this happens, but it is fixable.
What should I do if my bike wont start?
Replace the plugs, disconnect the king lead and turn the engine on the starter to allow oil pressure to build up and fuel to be drawn through the system. Refit the king lead and try to start it… If there were contaminants in the gas, it could gum up the carb, so it might be worthwhile to drain the gas and refill with new gas.
What should the voltage be on a motorcycle battery?
If everything looks ok, next is checking the voltage. You can DIY this or take your battery to a local shop or auto parts store to check it out. You’ll also want to load test the battery with a digital voltmeter, leaving it attached to the motorcycle. The voltage reading should range between 9.5 and 10.5 for about 30 seconds.
What should I do if my motorcycle battery wont start?
If you don’t see these symptoms or are otherwise unsure what to look for, the first step is ensuring that the battery is operational and providing the maximum voltage. To confirm your battery is still good, you should visually inspect it, check the voltage, and load test the battery. A visual battery inspection should involve:
What happens when a motorcycle battery is dead?
If your battery is completely dead, you motorcycle will not make any noise at all when you try to start it. How a motorcycle battery dies: If a motorcycle battery is not used and just sits, it will lose it’s capacity to power your motorcycle. There is also a phenomenon called parasitic drain.
What does it mean when your bike won’t start?
Has fuel, battery was enough to turn starter which usually means there’s enough to fire the ignition if bump-started, spark plug lead is firmly connected, compression seems to exist from the rhythm of the starter and how the rear wheel locked if bumped on the slightly loose surface outside the garage in too low a gear…
If everything looks ok, next is checking the voltage. You can DIY this or take your battery to a local shop or auto parts store to check it out. You’ll also want to load test the battery with a digital voltmeter, leaving it attached to the motorcycle. The voltage reading should range between 9.5 and 10.5 for about 30 seconds.