When did the Porsche Boxster convertible top change?
The 2003 and 2004 models were reasonably similar. In 2003, the Boxster received a styling update, including updating the rear window from plastic to glass. This required a new convertible top pattern to be designed and the inclusion of a glass window as standard. The 2003 and 2004 models were reasonably similar.
Can you replace the wishbone on a Porsche Boxster?
Both ball joints are integrated into the two assemblies and are not replaceable (you must replace the entire control arm and/or wishbone). Removal of the control arm involves the following steps: disconnect the inner ball joint, and disconnect the attachment point to the wishbone (see Photos).
How to change the bushings on a Porsche Boxster?
The new replacement bushings are split down the middle, so they should easily slide onto the bar and into the bracket (see Figure 9 ). Remove the old bushings, and insert the new ones, making sure that you coat the bushings with some white lithium grease on the inside.
What kind of top does a Porsche Boxster have?
The 2003 and 2004 models were reasonably similar. With a Porsche convertible top from Auto Tops Direct, you get factory-style listings, deck seams that are heat-sealed like original, sewn-in retainer attachments, sewn-in hold steel down cable assemblies, and more.
What is the repair manual for a Porsche Boxster?
PORSCHE BOXSTER 986 SERVICE & REPAIR MANUAL (1998 1999 2000 2001 2002 2003 2004) – DOWNLOAD! Download Now PORSCHE BOXSTER 986 SERVICE & REPAIR MANUAL (1997 1998 1999 2000 2001) – DOWNLOAD! Download Now PORSCHE BOXSTER 986 SERVICE REPAIR MANUAL 1997 1998 1999 2000 2001 DOWNLOAD!!!
How to repair a Porsche Boxster convertible top?
When you get the new rod, line it up to the old one, and make sure that the two are exactly the same length. Alter the two adjustment points on the rod if necessary. To install the rod back onto the convertible top linkage, use a screwdriver wedged up inside the mechanism to obtain the necessary leverage to snap it on.
Where are the sensors on a Porsche Boxster?
This photo shows the group of sensors located on the right rear of the engine. The purple arrow shows the crank angle sensor or flywheel sensor, which reads the toothed flywheel as it rotates past the sensor (harness plug shown by yellow arrow). The orange arrow shows the camshaft timing advance solenoid (red arrow is the connector).
How do you replace microswitch on Porsche Boxster?
Unfortunately, at the time of this writing, the only way to replace this microswitch is to purchase the entire bracket assembly (about $130 from Porsche). The factory manuals recommend using a drill to move the cables while aligning the left and right side, however, after repeatedly doing this many times, I discovered a short cut.