When did the Harley Shovelhead engine come out?
A shovelhead engine is a V-Twin Harley-Davidson engine that was produced from 1966 to 1985. The name shovel comes from the coal shovel-like shape of the engine covers. When the timing is not correct, the engine can fail.
How do you set the idle speed on a Harley Shovelhead?
Set the engine’s idle speed by turning the idle adjustment screw, located on the carburetor. Turn it clockwise to increase the speed. Turn it counterclockwise to decrease it. The idle speed should be somewhere between 950 and 1050 RPM. Remove the outer cover pop rivets. Remove the outer timer cover.
Why does my Harley Davidson motorcycle not idle?
After changing the cams to s&s 510s with a gear drive and riding the bike for a week with no issues, it all of a sudden has an intermittent idle problem. I’ll start it, and it won’t idle – it’ll drop to zero and die.
What causes a Harley Davidson engine to stall?
A: Bob, the most common reason a m/c will act this way is because of an intake leak. Start the bike cold. Mist the intake flanges with brake cleaner. If your bike’s idle drops, or the engine stalls, you have an intake leak.
What kind of idle does a Shovelhead have?
I am working on an 80 inch Shovel with a B on it right now. Between the points and the B it is tough to get it to idle right. It seems to have a two step idle. Either 1200 or 600 rpm but NEVER 900. It will idle high for a bit then will settle down to the “too low” stage.
What causes a motorcycle to stall at idle?
Extremely lean motors can also stall out completely when given some light throttle. Another sign of lean running is the “hunting idle” where the motorcycle revs up randomly, changes RPMs, or takes forever to come down to idle.
How to get a long-stored Harley running again?
“IMO – 1st change the oil and filter as described above. Put a new AGM battery in it, drain the old gas by removing the rubber hose on the front of the tanks tank to tank. Refill with new gas and turn the key on. Listen for the fuel pump to start and stop, turn key off, and repeat. This time crank it up and let her idle a while.
What should I do if my Harley Bike wont start?
“Has the engine been started or the crank turned since you took possession of the bike?” asks 2013 FLHTK. “Might want to remove the plugs, spray some fluid (Marvel Mystery Oil), place the bike in fourth gear, and move the rear wheel manually.” “Ain’t that complicated,” adds Notgrownup.
What kind of oil filter does a 1975 Shovelhead have?
Bought a 1975 Shovelhead a while back from a very shady character and among other things, when you start the engine, it starts puking tons of oil all over the floor. There is a braided metal line about 6-8″ long with a small filter on the end of it. Looks like a crank case breather line, on the right side of the engine.
How did the Shovelhead bike get its name?
The first Shovelheads released came out with aluminum cylinder heads borrowed from the Ironhead Sportster but with a redesign and a ten percent bump in power. Rocker boxes replaced the valve covers and the visual similarity to coal shovels earned the new bike the name “Shovelhead.”
When did the Low Rider Shovelhead come out?
In 1977 the Low Rider appeared, another sales hit. 1978 Harley-Davidson 74-inch FLH Shovelhead. The bagger types (those who liked the King of the Highway touring package, with batwing fairing and saddlebags) still had their FLHs, but now the market was expanding. Slowly. Too slowly, for the likes of AMF.
What’s the value of a 1976 Harley Shovelhead?
1976 Harley-Davidson Shovelhead , This 1976 harley davidson shovelhead 1200 runs good, in excellent shape, new paint job, new tanks, needs a little TLC must sell because of being disabled, this bike is worth a lot more. If interested and want to know anything please call (989)-464-1476. Matt. $4,000.00 9894641476
What was the problem with the Harley Davidson shovelhead engine?
With the United States involved in the 1973 oil crisis, gasoline had a much lower octane and consistency that severely hurt the engine’s performance. Engine knock became a large problem; causing overheating that led to blown gaskets and damaged head bolts.
When did the Harley Shovelhead trike come out?
One of a Kind! 1976 Shovelhead TRIKE! Manufactured from 1966-1985 the Shovelhead is one of those most iconic engines ever made by HD. This is a full custom trike and gets WAY more attention then any bike in our garage (other then our custom 99 Springer with on board air ride suspension). Run’s like a champ and sounds like NO OTHER!
What kind of engine does a 1976 Harley Davidson have?
1976 Harley-Davidson Shovelhead , 1976 Shovelhead, completely rebuilt engine. Engine has been bored 30 over so it is about 1340cc. It has a 5 speed transmission. It has been converted from a points condenser to an electronic Dyna.
Where is the advance timing mark on a Harley Shovelhead?
Aim the timing light at the inspection hole. Rotate the sensor assembly with the screwdriver so that you can see the front cylinder advance timing mark. Center the mark in the timing inspection hole. Tighten the timer plate studs. Reinstall the gasket, inner cover, inner cover screws and timer cover.
What’s the best way to time a Shovelhead?
Aim the timing light at the inspection hole. Rotate the sensor assembly with the screwdriver so that you can see the front cylinder advance timing mark. Center the mark in the timing inspection hole. Tighten the timer plate studs. Reinstall the gasket, inner cover, inner cover screws and timer cover. Install the new outer cover rivets.
What was the price of a Harley Shovelhead in 1982?
1982 Harley-Davidson Shovelhead , 1982 classic belt drive FLH runs and rides great original paint like new tires approximately 45k miles on the bike many extra parts go with it. $7,700.00 5025926727 1982 Harley-Davidson Shovelhead , 1982 Harley FLH.
In 1977 the Low Rider appeared, another sales hit. 1978 Harley-Davidson 74-inch FLH Shovelhead. The bagger types (those who liked the King of the Highway touring package, with batwing fairing and saddlebags) still had their FLHs, but now the market was expanding. Slowly. Too slowly, for the likes of AMF.
What kind of transmission does a Harley Davidson shovelhead have?
The 4-speed transmission was a separate unit. Both primary drive and final drive were chain. The Harley-Davidson Shovelhead motor saw numerous changes over its 17 years in production. For the first three years, it ran a generator and kept the old kidney-shaped timing cover from the 1958-1965 Panhead.
What’s the difference between a Shovelhead and a new Shovelhead?
A new belt-final drive gave quieter operation with no adjustment or lubrication needed. The new model also featured a redesigned frame and engine-mounting system, with the swing-arm bolting directly to the (also new) five-speed transmission. Several other upgrades included a spin-on oil filter.