What would cause ABS light to come on and off?
The four common reasons that typically cause this light to turn on include a malfunctioning ABS module, low levels in the fluid reservoir, broken wheel speed sensors, or the system is turned off. Your ABS actually shares some important components with another system in your vehicle: your traction control system.
How do you reset the ABS light on a Honda Odyssey?
1. Drive vehicle over 30 km/h (19 MPH) for at least one minute. 2. Turn ignition switch OFF. 3. Ground terminal 9 of Data Link Connector with a suitable harness. 4. Turn ignition switch ON while grounding terminal 9. Do not depress brake pedal. 5. After 3.0 seconds, the warning lamp starts flashing to indicate the malfunction code No. (See NOTE.)
Why are the traction control lights on on my Honda Odyssey?
2012 Honda Odyssey EX-L – had issue with ABS and TRaction control lights on, door would not open unless ignition off. This procedure with pin 4 and 9 and light braking worked quickly, thanks. Practiced once, got on 2nd try. If not covered by warranty (or Honda claims damage), Honda wanted $280 just to diagnose.
How do I get my Honda ABS to go off?
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).
What does the ABS light on the dash mean?
The anti-lock brake (ABS) indicator light on your dash should come on during the system’s self-check when you start the engine, but should go out shortly afterward. If the light comes on again later or stays on, it’s a sign that there’s a problem with the system. If the light comes on,…
1. Drive vehicle over 30 km/h (19 MPH) for at least one minute. 2. Turn ignition switch OFF. 3. Ground terminal 9 of Data Link Connector with a suitable harness. 4. Turn ignition switch ON while grounding terminal 9. Do not depress brake pedal. 5. After 3.0 seconds, the warning lamp starts flashing to indicate the malfunction code No. (See NOTE.)
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).
Why do the lights go off on my Honda Odyssey?
I recently started having this trouble with my 2002 odyssey. The TCS and ABS lights come on and go away intermittently. I took it to the honda dealership and they ran the initial tests and basically cleared the lights. I drove it home no lights, once parked I shut off the engine, restarted it and the lights came back on.
Where are the fuses on a Honda Odyssey?
Check Fuse # 50 (30A) in the Under-hood Fuse/Relay Box. Check ground in the motor power circuit. Check Fuse # 14 (7.5A) in the Passenger’s Under-dash Fuse/Relay Box. Check ground and a loose connection in the Under-dash Fuse/Relay Box and the ABS Control Unit. Check ground in the MCK circuit. Check pump motor relay in the Under-hood ABS Relay Box.