What will happen if I disconnect the MAF sensor?
If you unplug the mass air flow sensor the car will start. If you try to plug it in while it’s running the car will die.
What’s the problem with the Peugeot 406 MAF sensor?
In first gear it felt fine, but between 2nd and 5th the turbo was late in kicking in, it took until 3000 rpm until it kicked in, which in real world driving conditions meant an awfully long lag period then a sudden burst of power making it not safe for pulling out of junctions/roundabouts or overtaking.
How to contact mass air flow sensor on a Peugeot?
If you wish to contact me direct, my email address is below or DM me on Instagram. Thanks Chris That Running Guy An error occurred while retrieving sharing information. Please try again later.
How to troubleshoot a mass air flow sensor?
Check the connector for a correct fit and good contact. 2. Check the mass air flow sensor for damage. 3. Check the measuring elements for damage. 4. Check the voltage supply with the ignition switched on (circuit diagram for pin assignment is necessary). Ref. value: 7.5 -14 V. 5.
Can a Peugeot 407 speedometer be read on another car?
Case Details: When installed on another 407 it reads correctly. Since the speedometer read correctly on another vehicle it is not faulty. What needs to be checked are the ABS system and wheel speed sensors. A scan tool check is the ideal way to check them.
In first gear it felt fine, but between 2nd and 5th the turbo was late in kicking in, it took until 3000 rpm until it kicked in, which in real world driving conditions meant an awfully long lag period then a sudden burst of power making it not safe for pulling out of junctions/roundabouts or overtaking.
If you wish to contact me direct, my email address is below or DM me on Instagram. Thanks Chris That Running Guy An error occurred while retrieving sharing information. Please try again later.
What kind of HDI does a Peugeot 406 have?
The early 2.1s and late 2.0s are more complex than the 2.0 HDi fitted to the 406. Confusing!! This is my 2nd 2.1 hdi 406…. (30% Biodiesel OK for 1998+) But NOT veg oil.
Where does the air mass flow meter fail?
Sounds the same as my pug 406 air mass flow meter, its near the airbox and they fail. The car goes into get you home mode which is eff all power but running, makes you think its about to die but will run fro ever like this. Piece of piss to replace ebaylinky and cheap to boot…