What was the error code on my Honda Accord?

I used to have both P1166 and P1167 error codes on my 2001 Honda Accord (F23A4 engine). I fixed the P1166 by replacing the O2 sensor. For about a day, everything looked wonderful (i.e. no check engine light on). Then, (after a day), the dreaded check engine light turned on again.

How much does it cost to repair a Honda P1167 code?

An error occurred while retrieving sharing information. Please try again later. What does this mean? The cost of diagnosing the P1167 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

What does P1167 stand for in EVAP code?

The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat. If it is anything like a evap code where the computer has to relearn the sensors parameters under varying load conditions by doing tests etc.

Is the Honda Accord engine compatible with Amazon?

Amazon (as well as many part websites) might claim it is not compatible with your Honda Accord, since many part websites does not allow you to specify the specific engine code of your car. This causes such confusion. The same part was also proposed in one of the comments (check that of “Boris the Spider”) on the P1167 code explanation here.

What does the book say about p1166 and P1167?

The book says that both P1166 and p1167 is defined as the primary air/fuel sensor heater malfunction (not secondary). – shuva Nov 3 ’17 at 6:46 The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM).

What does p1166 stand for on a heater fuse?

P1166 indicates a blown or malfunctioning heater core fuse. I know that O2 sensors have resistive elements inside that are activated when the engine is cold. O2 sensors operate more efficiently when they are hot. The heater element is on until the engine is at normal operating temp then it switched off.

What does the P1167 Honda engine code mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1167 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

Is the Denso 234-9025 compatible with the Honda Accord?

As indicated in many of its reviews and Q&As, the Denso 234-9025 Air Fuel Ratio Sensor is a right fit for the F23A4 ULEV engine. Amazon (as well as many part websites) might claim it is not compatible with your Honda Accord, since many part websites does not allow you to specify the specific engine code of your car. This causes such confusion.

When does the O2 sensor turn on and off?

I know that O2 sensors have resistive elements inside that are activated when the engine is cold. O2 sensors operate more efficiently when they are hot. The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat.

How long does it take to diagnose Honda P1167 code?

An error occurred while retrieving sharing information. Please try again later. The cost of diagnosing the P1167 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What does it mean when your Honda Accord says p1259?

P1259 specifically means that there is an issue with the VTEC circuit itself. Although, mechanical issues can cause the code to register as well. If you are unsure of the oil weight used in your Accord’s last oil change, this would be a great place to start.

When to check the transmission fluid on a Honda Accord?

Checking the transmission fluid in your Honda Accord is an important part of a regular maintenance schedule. Thankfully, there’s an easy way to check it. This article applies to the Honda Accord (1990-2002). Transmission fluid, which is often forgotten, keeps your automatic gear changes nice and smooth.

Where is the malfunction indicator light on a Honda Accord?

Should an engine management component fail, the incorrect (or implausible) signal is recognised by the PCM, which stores a Diagnostic Trouble Code (DTC), and where appropriate, illuminates the Malfunction Indicator Light (MIL)/Check Engine Light (CEL) in the instrument cluster.

What does code 16 mean on Honda check engine light?

If any codes are present, they will blink a sequence in the MIL to indicate a system or component failure. The MIL will blink longer to represent the first digit and then will blink short for the second (for example 1 long and 6 short would be code 16).

Where is the fault code reader located on a Honda?

In order to retrieve any stored DTC’s, either a fault code reader must be connected to the vehicle’s data link connector (located above the Service Check Connector), or read from the MIL in the instrument cluster. The service check connector (2-pin) is located under the dashboard, above the passenger side kick panel.

Where is the service check connector on a Honda?

The service check connector (2-pin) is located under the dashboard, above the passenger side kick panel. By default it is inserted into a green rubber housing. for 92-95 models it is gray, 96-00 models its blue.

What is the diagnostic code for a Honda check engine light?

Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. P1201 Cylinder 1 Misfire – Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301

How much does it cost to repair a Honda p1166 code?

The cost of diagnosing the P1166 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

What are the trouble codes for Honda OBD-2?

Honda Specific Trouble Codes Code Description P1106 Barometric Pressure Circuit Range/Perfor P1107 Barometric Pressure Circuit Low Input P1108 Barometric Pressure Circuit High Input P1121 Throttle Position Lower Than Expected

Are there any trouble codes for Honda Civic EX?

No park no reverse making a loud grinding noise like it’s almost engaging .tried range sensor .what other sensors control those gears… P0502 vehicle speed sensor location.. I am trying to find the exact location of my sensor on my 2016 Honda Civic EX..

When is the p1457 Honda code detected?

The cost of diagnosing the P1457 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1457 HONDA code detected? The P1457 code is detected when the EVAP system has a very small leak.

What is the OBD2 code for a Honda?

OBDII Honda Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.

What is the read and clear code on a Honda?

Read and clear codes. Specifically, the Innova 3040E pulls engine, ABS and EVAP trouble codes in Honda and Acura vehicles. You can diagnose the CEL as well as the ABS light and turn them off. You can also check your car’s emission readiness.

What are the trouble codes for Acura RDX?

Hello first, thank you for giving us the opportunity to ask questions 🙂 In the self diagnostic system of my 2008 acura rdx I have the following codes : ENG 324 METER 294 METER 374 METER 377 METE… Note: The forum includes Honda and Acura brands together.

Navigation