What transfer case does a TJ have?
Jeep introduced the NP 241OR RockTrac transfer case in the Rubicon package in the TJ (and continued it in JK) Jeep Wrangler. The NP241OR has a 4:1 low gear ratio acheived through planetary reduction.
What are the splines on a Jeep transfer case?
The stock rotation on the New Process transfer case depends on the year of the vehicle and the stock transmission used. The rotations are approximately 13 or 23 degrees. The input shaft spline on these transfer cases will be either 21 or 23 splines.
Are there transfer cases for the Jeep Wrangler JK?
Jeep introduced the NP 241OR RockTrac transfer case in the Rubicon package in the TJ (and continued it in JK) Jeep Wrangler. The NP241OR has a 4:1 low gear ratio acheived through planetary reduction. The NP241OR is only available with the Rubicon trim level in the Wrangler TJ and Wrangler JK.
How many degrees does a Jeep transfer case have?
The rotations are approximately 13 or 23 degrees. The input shaft spline on these transfer cases will be either 21 or 23 splines. Each input shaft for these 2 counts is a different length.
What kind of lubricant is in a Jeep transfer case?
Drive Positions and Shift Controls: 2H, 4H, 4L and Neutral. Ranges selected via floor mounted shift lever. 4H and 4L ranges are undifferentiated. Case Configuration: One piece cast iron with aluminum front/rear bearing caps. Lubricant Capacity and Type: 4 pints (1.9 liters) SAE 85W-90 gear lubricant API grade GL-5.
How many miles does a 1994 Jeep Wrangler have?
We bought it used about a year ago, with 181k miles on it. Now it has 185k. It is a super fun car in the summer, to take the top and doors off is awesome. Almost without fail, we would get some kind of compliment on the car at a stoplight. They are quite susceptible to rust, depending on where you live.
How old is the last 1992 Jeep Wrangler?
I find very few con, considering its 23 years old. This 94 Jeep is the last of the real Jeep Wranglers.
Why is my 1992 Jeep Wrangler losing oil?
There is a slow oil leak at the rear main seal that causes it to slowly lose oil while you drive. You have to check the oil every time you fill up, because there isn’t a low oil sensor. Replacing the seal would require a $10 seal, but to install it you would have to drop the transmission. We’re in about $2,000 in repairs to the car.
How much would it cost to rebuild a 1992 Jeep Wrangler?
It would be $6000 for a rebuild, or $4500 for another engine with 145k on it. We decided that we will try to rebuild it ourselves, rather than sell it for parts or as a “mechanics special”.