What tools do you need to change a CV boot?

What tools do you need to change a CV boot?

What Tools Do I Need to Change a CV Joint?

1. Vehicle Jack. Removal of a CV joint requires that you jack the vehicle off the ground to allow access to remove the wheel and components from the wheel hub.
2. Lug Wrench.
3. 3/8″ Drive Socket Wrench Set.
4. Tie Rod Puller.
5. Hub Socket.

When do you need to replace a CV boot?

A clicking CV joint will need to be replaced, as most CV joints are usually not serviceable. CV boots serve a simple but important purpose and allow the CV axles and joints to stay clean and enjoy a long service life. If you notice or suspect that your CV boot may be damaged, have a professional technician,…

What happens when a CV axle boot goes out?

This flexible joint is covered in a rubber boot that is referred to as the CV Boot. This boot serves as a simple dust cover for the CV joint meant to keep out dust and dirt, and keep in the grease that lubricates the CV joint. When a CV axle boot goes out, it opens up the potential for the CV joint to become damaged by contamination.

What kind of boot is used for CV joint?

This flexible joint is covered in a rubber boot that is referred to as the CV Boot. This boot serves as a simple dust cover for the CV joint meant to keep out dust and dirt, and keep in the grease that lubricates the CV joint.

Do you need to replace a CV axle?

A clicking CV joint will need to be replaced, as most CV joints are usually not serviceable. CV boots serve a simple but important purpose and allow the CV axles and joints to stay clean and enjoy a long service life.

How to easily replace a CV boot without dismantling the joint?

How to easily replace a CV boot without dismantling the joint, using a cone tool and an universal CV boot. All stages step by step. This video does not constitute or replace a real specialized technical manual, and was only made ​​for convenience and educational purposes. “TutoBuild Eng” makes no warranties of any kind and accepts no liability.

How do you install a new CV boot?

Step 2: Install the new boot. CV boots come with pre-cut grooves that you just need to open and install the boot over the axle area. Once it is over the axle area, apply the glue supplied with the boot kit and stick both ends of the boot together. As soon as it dries up, the glue becomes as flexible as rubber.

When to replace CV boots on your ATV?

https://www.rockymountainatvmc.com/Sa… Replace your worn out, inexpensive CV boots before dirt and grime destroy your expensive CV Joint. A good CV boot seal is critical for CV joint protection and longevity on your ATV. The Tusk CV Boot Banding Tool allows you to easily and properly secure your CV boot bands on your UTV/ATV.

Where does the CV boot go on an axle?

Notice that the smaller end of the CV boot goes on the axle shaft area and the larger opening goes over the outer CV joints. If you look closely enough, you will notice that there are grooves to indicate where the boot holds in place on both ends. Step 5: Install the clamps. Once the CV boot is in place, proceed to install the metal clamps.