What to use to remove nut from sway bar?
The studs that hold the link to its threaded mount sheared off, leaving the sway bar to bounce all over freely. Hold the bolt in place with the hex wrench while you remove the nut. John Lake, 2015 To remove the lower bolt on the sway bar mount, you need a properly sized hex wrench (Allen wrench) and an open end wrench.
How to get rid of bad sway bar links?
FASTEST WAY TO REMOVE BAD SWAY BAR LINKS…Bam Off! – YouTube If playback doesn’t begin shortly, try restarting your device.
How to repair a broken sway bar mount?
How To Replace a Broken Sway Bar Link 1 Diagnosing a Broken Sway Bar Mount. You may not be trying to break any records, but you still need tight suspension. 2 Locate and Examine the Broken Mount. The sway bar mount is pictured in the yellow oval. Support the vehicle safely… 3 Removing the Lower Sway Bar Mount Bolt. More …
What happens to the sway bar when the wheel is off?
With the vehicle in the air and the wheel off, you have access to the sway bar link. In many cases, the mount will actually be broken, as it was on this vehicle. The studs that hold the link to its threaded mount sheared off, leaving the sway bar to bounce all over freely.
Can you remove the nut from a sway bar?
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.
How can I remove a bad sway bar link?
Identify the bad link. A bad link: Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture).
How to change the sway bar on a Nissan Maxima?
Note: This information and pictures were performed on a 1996 Nissan Maxima on the drivers side front wheel. Other vehicles may look different or have different requirements, check your service manual. Loosen the wheel lug nuts. Loosen them slightly, but do not remove. Jack up/lift the car.
What kind of wrench do you need to remove a sway bar?
To remove the lower bolt on the sway bar mount, you need a properly sized hex wrench (Allen wrench) and an open end wrench. The hex wrench will be used to lock the bolt in place while you remove the nut from the back of the bolt. It’s a little tricky getting your hands on everything you need to hold onto, but it’s there.