What to look for when your lights are not working?
Also look for bad, wet, corroded, or damaged sockets. Check for any areas that are exposing the wires or bulbs to moisture too. A short in lighting is when electricity is going where it isn’t supposed to and nothing is slowing it down.
What to do if your garage door opener is too far away?
This switch is usually a simply touch-lever mounted on the end of the track near the motor unit, and if it is too far away, the motor will stop the door before it fully opens. The solution is to move the switch closer to the motor unit.
What should I do if my halogen light is not working?
If you’re using halogen bulbs, checks the volts for the light fixture at the end of the grouping. If it’s less than 10 volts you’ve got a problem. Just switch to LED lights, they’re all-around better for many reasons. If it’s none of those, check the connection to the power cable to ensure the pins are firmly in the copper strand.
What should I do if my landscape lights are not working?
Troubleshooting Your Landscape Lighting Transformer Look at the ends of the cable to ensure the copper strands aren’t touching. If they aren’t, check the fixture connection points for shorts. You can also recalculate the wattage to ensure you’re not exceeding the transformer’s wattage (watts = amps x volts).
Also look for bad, wet, corroded, or damaged sockets. Check for any areas that are exposing the wires or bulbs to moisture too. A short in lighting is when electricity is going where it isn’t supposed to and nothing is slowing it down.
Why does my garage door opener not close?
Garage Door Light Flashing But Won’t Close When you see you garage door opener lights flashing and the garage door will not close, it could be the LOCK button or the safety reversing sensors. NOTE : If necessary, you can close the garage door by pressing and holding the door control push bar until down travel is completed.
Why does my Craftsman garage door not close?
Check if the garage’s fuse is in good condition or the circuit breaker has not tripped open. When the garage door does not close, and the lights flashes, it means the problem is with the safety sensor. There are a few things which can cause this. With the diagnostic feature on Craftsman, you can know what exactly the issue is.
If you’re using halogen bulbs, checks the volts for the light fixture at the end of the grouping. If it’s less than 10 volts you’ve got a problem. Just switch to LED lights, they’re all-around better for many reasons. If it’s none of those, check the connection to the power cable to ensure the pins are firmly in the copper strand.