What to do when your pioneer radio wont turn on?
Suggest you double check the speaker wires are not shorting out on either left or right channels before attempting reset the lock. Or if this does not work try pressing the “STANDBY/ON” and “STOP” buttons simultaneously on the front panel.
Why does my pioneer x-hm71 timer flash red?
It cost £30 a pop for DK AVS to reset each X-HM71 which developed the mysterious flashing red timer light after the 12 month warranty had expired. The third one failed after just a couple of months so was returned for a full refund.
What kind of light does a pioneer mini HiFi flash?
Do you have a Pioneer mini-hifi (X-HM71-S, X-HM71-K or X-HM81-S, X-HM81-K) or amplifier (X-HM20) that suddenly stopped working? Maybe all it does when plugged in is flash a little red / blue light on the front panel and refuses to switch on.
Why does the timer light flash when there is a fault?
The timer light will flash in a particular timing sequence to indicate to an engineer what area the fault is in. Some are recoverable by the end user just by pressing the power button again. Other more serious errors, that can cause permanent damage, are not recoverable by the end user.
When does the selected position indicator light stop flashing?
The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON. If any of the shift conditions are not met, the indicator position light will continue to flash. You cannot be in gear for it to work.
What does the blinking 4 wheel drive indicator mean?
So what is that 4 wheel drive indicator blinking on your dashboard means? The purpose of the 4 wheel drive light is to indicate when you have engaged 4WD mode by selecting 4H. When the light flashes continuously for more than 30 seconds it signifies there is a problem somewhere on your drivetrain system and that 4WD has not engaged properly.
Why does the 4 wheel drive light stop flashing?
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.