What to do when you change spark plugs?
When changing the spark plugs, always ensure that the spark plug threaded portion of the shell (from the spark plug seat) is same length (or very close to) the O.E. spark plug. If the threaded portion is slightly longer, spark plug indexing washers can be used to obtain the desired spark plug reach.
Do you need to set the spark plug gap?
Spark Plug Gap setting is important for proper engine operation. To set the spark plug gap correctly, you need to use a spark plug gap tool. For reference, see our spark plug gap chart below, this chart converts metric measurements to standard.
Where is the spark plug gap on a champion?
For Champion spark plugs it is a little less logical and is as listed below: Spark plug gap is where spark plug spark discharge is designed to take place. On a conventional spark plug, it is the area between the center and the ground electrode.
How much HP can you gain by replacing spark plugs?
It is not uncommon to gain as much as 20 Hp just by replacing used spark plugs. Used spark plugs are hard to fire as the gaps are worn out, and insulation properties of the ceramic is compromised by solid combustion deposits and old fuel saturation.
Why do I need to change my spark plugs?
It’s important to replace the plugs with what the manufacturer recommends. NGK recommends not using any anti-seize compounds on the plugs, as the lubricant may cause the installer to over torque the plug. The NGK plugs have a zinc shell plating that is designed to prevent seizure to the cylinder head, as well as prevent corrosion.
Can you change spark plugs in a 1999 Acura Integra?
Changing plugs in a 1999 Acura Integra is a fairly simple job, however there are some tips along the way worth understanding. There’s several things you’ll want to look for while inspecting spark plugs. The electrode may be worn out, you may often see it rounded rather than flat. You want to check the plug gap, using a simple tool.
What should the gap be between spark plugs?
You want to check the plug gap, using a simple tool. For my car the recommended gap is 1.1 mm, you can check your owners manual for this information. You want to look for oil fouling or carbon deposits around the spark plug tip.