What to do if your villager engine wont start?
Pull the fuel pump relay out of the box using the needle-nose pliers. Crank the engine over three or four times to relieve the fuel pressure. The Villager will not start. Disconnect the negative battery cable using the appropriate wrench. Place the drain pan under the radiator petcock.
Where is the knock sensor on a villager?
by Cayden Conor. The knock sensor on the 1993 through 1998 Mercury Villager 3.0-liter engine is located under the intake manifold. It checks for pre-ignition, otherwise known as spark knock. If it senses spark knock, it sends a signal to the programmable control module (PCM), which is the engine’s computer.
Where is the accelerator cable on a villager?
Loosen the locknut on the accelerator cable, then pull the cable out of its bracket on the top of the upper intake manifold. If the Villager has a speed control actuator, loosen the locknut, then remove the actuator from its bracket on the top of the upper intake manifold. Set it aside.
Can a 3.1L engine leak coolant?
Once out of warranty… well, you know that you’re the one that’s gonna’ have to pay for it. If you do own a vehicle equipped with a 3.1L or 3.4L engine, chances are that you have already experienced this ‘intake gaskets leaking coolant’ condition (and have repaired it), or you’re experiencing it right now or will be soon enough.
Pull the fuel pump relay out of the box using the needle-nose pliers. Crank the engine over three or four times to relieve the fuel pressure. The Villager will not start. Disconnect the negative battery cable using the appropriate wrench. Place the drain pan under the radiator petcock.
How do you remove PCV hose from intake manifold?
Pull the PCV hose from the upper intake manifold. Remove the five Allen bolts from the upper intake manifold–these bolts hold the upper and lower intake manifold together. Separate the two manifolds, then clean the gasket mating surface of all gasket material. Unplug the electrical connectors on the six fuel injectors.
How to replace a Mercury Villager knock sensor?
How to Replace a Mercury Villager Knock Sensor. 1 Step 1. Open the relay box, located near the driver’s-side fender well. Read the underside of the cover to determine which relay is the fuel pump 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
Pull the PCV hose from the upper intake manifold. Remove the five Allen bolts from the upper intake manifold–these bolts hold the upper and lower intake manifold together. Separate the two manifolds, then clean the gasket mating surface of all gasket material. Unplug the electrical connectors on the six fuel injectors.