What to do if your Pontiac Grand Prix ignition switch stops working?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. Check out my gear head channel.
How do I change the ignition switch on my car?
Click here to view that post. Now on to changing the ignition switch. Disconnect the battery. The first step is to remove the lower trim panel under the steering column. There may be some screws at the bottom of this panel that have to be removed. This car did not have any.
How do you remove a lock cylinder Shift Solenoid?
To remove it use a small screwdriver to depress the locking tab, rotate it and lift off of the housing. When removing the forward screw you will also be removing the lock cylinder shift interlock solenoid. Finish removing the switch by cutting the wires ties that hold it to the other harnesses and install the new switch in reverse order.
How do you remove a key buzzer switch?
The cream colored piece to the right with two wires attached is the key buzzer switch. To remove it use a small screwdriver to depress the locking tab, rotate it and lift off of the housing. When removing the forward screw you will also be removing the lock cylinder shift interlock solenoid.
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. Check out my gear head channel.
How do you remove ignition switch from car?
Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right. Pull on both the paperclip and the screwdriver to gently slide the switch out of its current position.
How can I Turn Off the ignition without a key?
Be sure to make the hole large enough for you to insert your screwdriver, and drill to the back of the key slot. Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right.