What to do if your key fob gets wet?
After fishing your key fob out of whatever puddle, pool, or washing machine, focus on getting as much water out of the fob as possible before opening it up. First, flip the fob button side down and let as much water drain out of it as possible. Shake out as much water as you can and then buff the fob dry with a clean cloth.
What to do if your key fob battery is bad?
A bad key fob battery can give you a real headache while you are trying to reprogram it. The batteries are often cheap and also easy to replace. Check your owner’s manual if you do not know how to replace them. Get in the driver’s seat with your car keys and the remote and close all the doors.
How can I reprogram my Remote key fob?
Make sure that the ignition is not in the radio mode, and do not start the engine. Press the lock button on the remote key With the key in the ‘On’ position, press the fob’s lock button and turn the key back to the ‘Off’ position. Repeat this process at least three times, ending the cycle with the key in the ‘On’ position.
How do you turn off a remote control FOB?
4. Press the Lock Button on Remote. With the key in ‘On’ position, press the lock button on the fob and turn the key back to ‘Off’ position. Repeat this process at least three times ending the cycle with the key in ‘On’ position.
What to do if your key fob is in the washer?
Try resetting fob by taking the battery out and reinstall. If you have maxcare lifetime warranty, you get up to 3 new fob’s. So there was an incident with one of my key fobs and it ended up in the washer .. Since that time, it is now acting strange. The door lock button works but then flashes the red led (16) times afterwords.
What happens if your key fob gets wet?
Battery failure – A wet circuit board can also cause the key fob battery to dump its charge. At best, you’ll end up with a dead battery. At worst, the battery could leak or even explode. After fishing your key fob out of whatever puddle, pool, or washing machine, focus on getting as much water out of the fob as possible before opening it up.
What to do if your key fob doesn’t work?
If the key fob doesn’t work at all, first make sure the fob doesn’t need reprogramming after being out of commission. Remember that it’s not guaranteed that your key fob will work after completing all of the above steps. So if your key fob bites the dust, don’t get mad – chalk it up as a learning experience.
How to change the battery on a key fob?
Press start button with the fob and it worked…Sprayed inside of fob with electronic cleaner replaced battery and worked for about 3 hours and battery went dead. Took apart sprayed with cleaner and replaced battery again worked for 1 day.