What to do if your Jeep Liberty heater is not working?
If your Liberty has a built in temperature gauge, take a look at it and see if it is in the spot it is normally in after a bit of driving. If it looks like it is colder than normal, that’s a pretty good indication that there is something wrong with the thermostat.
Why is my Honeywell air conditioner not working?
If your cooling is not working, it’s probably due to issues with the following: 1 Air Flow 2 Compressor 3 Thermostat Wiring 4 Furnace or Heating System 5 Thermostat Device
What to do if your cooling system is not working?
To begin fixing your cooling, continue to the Air Flow section. 1. What best describes the air coming out of your vents? NO AIR – Continue to the Furnace or Heating System section. ROOM TEMPERATURE – Continue to the Compressor section. WARM/HOT – Continue to the Thermostat Wiring section.
What to do if your coolant temperature sensor is bad?
Connect the digital multi-meter to the coolant temperature sensor by connecting the red probe to the terminal end of the coolant temperature sensor and the black probe to the solid grounding. Note the readings. Start the engine and let it run for a couple of minutes at least. Note the readings initially while the engine is cool.
Where is the a / C to heat control on a Jeep Liberty?
As with the Jeep Liberty, the A/C to heat control is the centre dial on your dash. This opens and shuts the gate behind the dash to determine how much hot or cold air goes into the system. This is operated by an electronic part called an actuator. It simply goes up and down to open and shut the gate.
Why does my Jeep Wrangler have no coolant?
However, even if there is no coolant smell, but an issue with the heater, it is a good idea to check these hoses for heat. If the engine is warm, then you should feel heat from the hoses as well. If not, then the coolant is not circulating properly and you could have air in the lines or a clogged heater core that needs a flush.
Connect the digital multi-meter to the coolant temperature sensor by connecting the red probe to the terminal end of the coolant temperature sensor and the black probe to the solid grounding. Note the readings. Start the engine and let it run for a couple of minutes at least. Note the readings initially while the engine is cool.
What to do if your Jeep Wrangler heater is not working?
So it may be beneficial for those with newer Jeeps to take a spin to the dealership, or trusted mechanic, for a diagnosis. This is the guy in charge of blowing air across the hot heater core, through the Jeep’s ventilation system, and into the cabin.