What to do if your Jeep Grand Cherokee cooling fan is not working?
If the fan does not operate, continue troubleshooting. Switch the wires to the opposite terminals. If the fan still does not operate, the cooling fan motor and assembly must be replaced. If the fan does operate, the vehicle must be taken into a professional service center for testing on the PCM, which controls the cooling fan relays.
What to do if your radiator cooling fan Wont Stop Running?
Remove the lid. Look on the inside of the lid and for the mapping of the fuses and relays with their location. Pull the cooling fan relay out of the box. Replace the cooling fan relay with a new one. A stuck closed relay is the only thing that can operate the cooling fan continuously with the key off.
Why is my computer cooling fan not working?
A stuck closed relay is the only thing that can operate the cooling fan continuously with the key off. The computer looses power with the key off and the same applies to the coolant temperature sensor. The relay, however, has direct power to one side, the same as a light switch.
Why is my Jeep radiator not turning on?
The fan will turn on after the temperature reaches about half. Usually comes on when the car is standing still due to the small amount of air circulating through the radiator. Too many mods to list… No the AC will turn the radiator fan on to pull air across the condensor.
What to do if your radiator fan is not working?
No the AC will turn the radiator fan on to pull air across the condensor. Your going to need to check for power at the fan, the fan can still be failed and spin just fine by hand, considering you dont have high or low I would lean towards a fan or fan connector concern.
How can I tell if my Chevy Aveo radiator fan is bad?
You can test the voltage going from the fan relay to the fan itself. If it is getting 12+ volts, the fan should be coming on. But if it’s not, which means the fan has gone bad. This video from Ratchets and Wrenches is a phenomenal resource on how to properly diagnose a wiring problem.
How does the cooling fan work on a Jeep Grand Cherokee?
The cooling fan in a Jeep Grand Cherokee keeps engine temperatures at the correct level by kicking on during times when the engine reaches higher-than-average temperatures. Without it, the engine can reach dangerous temperatures and damage engine components.
The fan will turn on after the temperature reaches about half. Usually comes on when the car is standing still due to the small amount of air circulating through the radiator. Too many mods to list… No the AC will turn the radiator fan on to pull air across the condensor.
No the AC will turn the radiator fan on to pull air across the condensor. Your going to need to check for power at the fan, the fan can still be failed and spin just fine by hand, considering you dont have high or low I would lean towards a fan or fan connector concern.
You can test the voltage going from the fan relay to the fan itself. If it is getting 12+ volts, the fan should be coming on. But if it’s not, which means the fan has gone bad. This video from Ratchets and Wrenches is a phenomenal resource on how to properly diagnose a wiring problem.
If the fan does not operate, continue troubleshooting. Switch the wires to the opposite terminals. If the fan still does not operate, the cooling fan motor and assembly must be replaced. If the fan does operate, the vehicle must be taken into a professional service center for testing on the PCM, which controls the cooling fan relays.
Why does my Jeep Grand Cherokee radiator not turn on?
When the negative wire is attached to the relay, the relay should have an audible click as it activates. If the relay fails to click, move the jumper wires to the second set of terminals in the event the wrong terminals were being used. If the relay fails to click it is bad. Check the radiator fan switch if the relay proves to be good.
What should the fan temp be in a Jeep Wrangler?
Actually, 226 is pretty average for the engine in traffic. Mine runs up to 228 or so in Houston, then backs off pretty rapidly once the fans kick in. The highest I’ve ever seen is 231 and that was getting stuck in an accident on Pikes Peak.
Where is the relay on a Jeep Grand Cherokee?
A Jeep has more than one relay that are the same (go by the relay number on the top or side of the relay) in the fuse box on the driver’s side fenderwell. Remove a known good relay and swap it with the radiator fan relay. Operate the vehicle and check the operation of the unit replaced.
Where does the radiator fan go when its hot?
Having said that Matt, as I already suggested, when its hot out I run right at the middle hash mark, when its cool I run just mm or 2 below, with a known fully functional fan. It has done this for the 1.5 years I have had it, first noticed while I was towing and it freaked me out for a second but it has NEVER gone above the 1/2 hash mark.
Why is the radiator fan not working on my Jeep Grand Cherokee?
If your Grand Cherokee has a bad engine temp sensor the radiator fan won’t know to come on, because the ECU won’t know how hot the engine is. You’ll need to locate and test the engine temp sensor. Depending on the model year and engine, the location varies. If it does end up being this sensor, they are very affordable.
Having said that Matt, as I already suggested, when its hot out I run right at the middle hash mark, when its cool I run just mm or 2 below, with a known fully functional fan. It has done this for the 1.5 years I have had it, first noticed while I was towing and it freaked me out for a second but it has NEVER gone above the 1/2 hash mark.
Why does my Jeep Wrangler have no heat?
This will also cause the engine to run hotter and will affect the temperature level of the Jeep’s heating system. However, even if there is no coolant smell, but an issue with the heater, it is a good idea to check these hoses for heat. If the engine is warm, then you should feel heat from the hoses as well.
Where is the fan on a Jeep Wrangler?
This is the guy in charge of blowing air across the hot heater core, through the Jeep’s ventilation system, and into the cabin. The fan is usually located behind the glove box and when it fails, you may still get cold or warm air through the vents, but it will be at a drastically lower pressure no matter what fan speed you select.
What to do if your Jeep Cherokee heater stops working?
If the heater has stopped working in your Cherokee, this process has failed in one way or another. A word of caution: If there is no coolant in your overflow, you can refill it by adding more to the overflow reservoir. There is almost never a situation where you would need to take the radiator cap off of the radiator to add coolant.
This will also cause the engine to run hotter and will affect the temperature level of the Jeep’s heating system. However, even if there is no coolant smell, but an issue with the heater, it is a good idea to check these hoses for heat. If the engine is warm, then you should feel heat from the hoses as well.
If the heater has stopped working in your Cherokee, this process has failed in one way or another. A word of caution: If there is no coolant in your overflow, you can refill it by adding more to the overflow reservoir. There is almost never a situation where you would need to take the radiator cap off of the radiator to add coolant.
What kind of heater does a Jeep Wrangler have?
Keep in mind, though, the newer the vehicle—such as JL Wranglers and JT Gladiators—the more electronics are involved in the heater system. So it may be beneficial for those with newer Jeeps to take a spin to the dealership, or trusted mechanic, for a diagnosis.
How does a radiator fan work when the AC is on?
The electric radiator cooling fan assembly is controlled by a thermoswitch located in the side of the radiator. At higher coolant temperatures, the switch closes to start the cooling fans. Any time the coolant temperature rises to higher than normal levels, the fan will start and continue to run until coolant temperature returns to a normal range.
What should I do if my radiator fan is not working?
A blown fuse is no big deal, and changing one does not cost a lot of money. If your car’s radiator fan is non-functional, check your car’s user manual and locate the fuse for the radiator fan controller or the fan. The fan itself often uses a big fuse of around 50A, while there might also be a separate small fuse to the fan control module.
Where is the radiator fan relay on a Dodge Grand?
If the Radiator fan control module has failed you will need to replace it with a new one there is no way to repair it. The radiator fan relay is located below the left front headlamp module. The headlamp module must be removed to access the relay. Open hood, disconnect and isolate the battery negative cable.
What to do if your Dodge Grand Caravan radiator does not turn on?
Test the resistance of the wire harness between the PCM connector terminal 26 and the sensor harness connector. Also check for continuity between PCM connector terminal 43 and the sensor harness connector. If the resistance is greater than 1 ohm , repair the wire harness as necessary.
Why do newer Jeeps have less fan failures?
The newer Jeeps are… newer, and as a result parts are failing a lot less often. I suspect that as they age and parts fail more, this knowledge will become a lot more common.
How to diagnose a Jeep JK radiator fan issue?
The Relay in the TIPM (K11) labeled “Radiator Fan Low” The dual relays over by the brake master cylinder labeled “Fan Relays” on the internet (Mopar Part 56055666AB) The lack of a P069X style code being thrown led me to believe this was a unique problem with only the “high” speed part of running the fan.
What does code p0480 mean on Jeep radiator fan?
Include a few extra bits of circuitry (more relays) that help trigger the fan on when the AC is running, or the engine temp crosses a certain level. In addition to throwing a P0480, these fans can also throw a code in the P069X range.
Why are the cooling fans not working on my car?
1. Engine running hot 2. Cooling fans do not function 3. Cooling fans stay on at all times Average rating from 129,472 customers who received a Vehicle Engine Cooling Inspection. Most modern vehicles use electric cooling fans to help pull air through the radiator so that it can keep the engine cool.
How can I tell if my Jeep Grand Cherokee radiator fan is good?
Check the radiator fan switch if the relay proves to be good. If the fan switch is good, check the radiator fan by using the jumper wires from the battery to the electrical connection on the radiator fan to wire it directly to the battery. If it fails to operate the fan is bad.
What happens when the thermostat is stuck open on a Jeep Cherokee?
When the thermostat is stuck open, the vehicle will be getting too much coolant. On the other hand, if it is stuck in the closed position, the radiator will not be getting any coolant at all.
Why does my Jeep Cherokee have too much coolant?
When the thermostat is stuck open, the vehicle will be getting too much coolant. On the other hand, if it is stuck in the closed position, the radiator will not be getting any coolant at all. If you do end up replacing the thermostat, make sure the new part is an exact match to your make and model of Cherokee.
What to do if your Jeep Cherokee overheats?
An oil change could be just the thing your Cherokee needs to chill out. Draining old oil, and refilling it with fresh oil, plus changing the oil filter will make it run better. But if the oil level is too low, you will definitely experience overheating. 6.
The newer Jeeps are… newer, and as a result parts are failing a lot less often. I suspect that as they age and parts fail more, this knowledge will become a lot more common.
The Relay in the TIPM (K11) labeled “Radiator Fan Low” The dual relays over by the brake master cylinder labeled “Fan Relays” on the internet (Mopar Part 56055666AB) The lack of a P069X style code being thrown led me to believe this was a unique problem with only the “high” speed part of running the fan.
How to troubleshoot a jeep PWM fan relay test?
Radiator Fan Motor Circuit Wiring Diagram (1999-2003 4.0L Jeep Grand Cherokee). TIP 1: The way I’ve designed the Jeep PWM fan relay test, you’ll need a scan tool that can read live data (not a code reader), since you’ll need to keep an eye on the engine’s coolant temperature with it.
What is the PWM code for a Jeep Grand Cherokee?
This tutorial will help you to diagnose the Pulse Width Modulated (PWM) fan relay on the 1999-2003 Jeep 4.0L Grand Cherokee SUVs and/or the codes P1491 ( Radiator Fan Control Relay Circuit ). The dealer, at the time of this writing, will charge you $95 (US) to diagnose it.
What are the symptoms of a bad PWM fan relay?
Symptoms Of A BAD PWM Fan Relay. The most obvious symptom of a BAD PWM fan relay is that your Jeep is gonna’ overheat. You’ll also see one or all of the following symptoms as the engine overheats:
How do you replace a cooling fan on a Jeep Grand Cherokee?
Pull the cover from the fuse box on the end of the panel. Using the fuse diagram on the inside of the cover, locate the fuse for the cooling fan and remove it with needle-nose pliers. If the metal link inside the fuse is broken, replace the fuse.
Radiator Fan Motor Circuit Wiring Diagram (1999-2003 4.0L Jeep Grand Cherokee). TIP 1: The way I’ve designed the Jeep PWM fan relay test, you’ll need a scan tool that can read live data (not a code reader), since you’ll need to keep an eye on the engine’s coolant temperature with it.
What to do if your Jeep Grand Cherokee radiator is not working?
The first thing that you would want to do is locate the fuse for your Grand Cherokee’s radiator fan and make sure that it hasn’t blown. If it is blown, replacing the fuse will only solve the problem for a very limited period of time. Unless the wiring issue is fixed, the fuse will blow again. The wiring harness itself can go bad.
This tutorial will help you to diagnose the Pulse Width Modulated (PWM) fan relay on the 1999-2003 Jeep 4.0L Grand Cherokee SUVs and/or the codes P1491 ( Radiator Fan Control Relay Circuit ). The dealer, at the time of this writing, will charge you $95 (US) to diagnose it.
Why is the radiator fan not working on my Mercury Grand Marquis?
Your Mercury Grand Marquis ‘s radiator fan has one of the most important jobs on the vehicle. It is the last line of defense between you and an overheating engine. If the radiator fan is not working, it’s a serious problem. Just because the radiator fan is not on does not mean that it is not working.
Your Mercury Grand Marquis ‘s radiator fan has one of the most important jobs on the vehicle. It is the last line of defense between you and an overheating engine. If the radiator fan is not working, it’s a serious problem. Just because the radiator fan is not on does not mean that it is not working.
What does it mean when your radiator fan is not working?
If the radiator fan is not working, it’s a serious problem. Just because the radiator fan is not on does not mean that it is not working. They are designed to only run when needed. If your Grand Marquis is running hot, and the fan is not running we’ve laid out the most common causes of this issue below.
Where is the relay on a radiator fan?
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.