What to do if a speaker wire does not work?
If it still does not work, switch the wires with the set of speakers that does work. If the good set of speakers suddenly does not play then it is a faulty speaker wire. Sometimes there will be an issue where the stereo seems to work perfectly fine, then suddenly becomes “choppy” or the sound completely cuts off for a few seconds.
How can I tell if my stereo wire is faulty?
Make sure that there is no exposed metal near the wires or this could not only short out the wires, but could damage your stereo. Also, if you smell a sort of burning while your stereo is playing then stop the stereo immediately and check the wiring. This is an indication that the wiring is faulty.
How can I tell if my speakers are faulty?
Check to make sure that the wires are properly connected at the amplifier and the speakers. Once you do that, play with the wires again and see if the sound still crackles or stops. If it does, then it is most likely faulty wires.
What does it mean when Your Stereo Is Burning?
Also, if you smell a sort of burning while your stereo is playing then stop the stereo immediately and check the wiring. This is an indication that the wiring is faulty.
Is there a constant power source for a stereo?
Make sure you connect the Yellow wire from the stereo, to the wire you identified as constant power earlier. If you do not locate a constant power source in the vehicles wire bundle, you can route one from the interior fuse box or splice it from a nearby source.
How to troubleshoot a car stereo that will not power?
Take a close look and make sure no wires are loose entering the harness. Make sure the harnesses are plugged into the car stereo. Trace back wiring from the car stereo’s control head power harness to the fuse block and verify that the wiring is all intact. If you encounter a fuse along the red wire, replace it.
Which is the ignition wire on a car stereo?
The ignition wire will be the pin that reads voltage only when the car is ON. Most modern after market car stereos use the same wire colors. Blue = Accessory (power antenna, amp, etc.) Make sure you connect the Yellow wire from the stereo, to the wire you identified as constant power earlier.
Do you need a fuse for a stereo head unit?
However, you’ll want to make sure this new power wire contains an inline fuse of the appropriate size. Once you have the stereo hooked up to constant power, you should never have to reset your stations again. Sounds like a problem in the way the head-unit was installed.