What size socket wrench do you need for an oil drain plug?
Before embarking on a project, for instance replacing your car’s engine oil, you need to decide which size socket wrench to use. You need a socket wrench to open the oil drain plug so the used oil can drain from the engine. First, turn on the car to warm up the engine. This thins the oil, allowing it to drain smoothly.
What kind of wrench do I need to change oil?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.
How big of a socket wrench do I Need?
For each particular job, it’s important to choose the size socket wrench that corresponds with the particular hardware. There are four common socket sizes: 1/4 inch (0.6 centimeters), 3/8 inch (0.9 centimeters), 1/2 inch (1.3 centimeters) and 3/4 inch (1.9 centimeters).
How big is a drain plug for an oil filter?
Oil filter wrench size ? and drain plug size socket ? By britdave, December 7, 2010in 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) Share Followers0
Before embarking on a project, for instance replacing your car’s engine oil, you need to decide which size socket wrench to use. You need a socket wrench to open the oil drain plug so the used oil can drain from the engine. First, turn on the car to warm up the engine. This thins the oil, allowing it to drain smoothly.
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.
For each particular job, it’s important to choose the size socket wrench that corresponds with the particular hardware. There are four common socket sizes: 1/4 inch (0.6 centimeters), 3/8 inch (0.9 centimeters), 1/2 inch (1.3 centimeters) and 3/4 inch (1.9 centimeters).
What’s the size of an oil drain bolt?
First off, I believe that 16mm may be an “odd” size, as both my box wrench and socket sets omit it, and jump from 15mm to 17mm. Anyway, I used a 17mm box wrench which worked fine… no “rounding” of the bolt. I know this thread is a month old, but… Just curious if those of you who did your own oil change can shed some light on how it went?