What size socket do I need for brake pads?
Hand Tools You at least need a set of 3/8″ (drive size) sockets set with sizes 8-19mm. Some vehicles use Allen or Torx bits for the caliper guide pins.
Should you replace caliper bolts?
For this reason — stuck caliper bolts — Carlson recommends replacing them anytime you replace your calipers. Doing so makes sense. Your brakes are a system that is put under enormous pressure and over months and years. Eventually, things wear out and rust.
Should you put Loctite on caliper bolts?
The repair manual says “Apply a high temperature thread locker (Loctite 272® or equivalent) to the caliper support bracket fasteners. If Loctite 272® (or equivalent) is not available, new caliper support bracket fasteners must be used.”
How are brake pads installed on a disc brake system?
After the pads are installed on a floating disc brake caliper type braking system, it’s time to remount the caliper to the steering knuckle. Pictured to the right are replacement General Motors caliper slides and bolts.
How do you remove rotors from brake pads?
Once the pads are off, remove the rotor. On many vehicles, you’ll need to remove the caliper mounting bracket in order to remove the rotor. The brake caliper bolts to the brake caliper mounting bracket which bolts to the spindle assembly. To remove the brake rotor, first remove the brake caliper and then remove the brake caliper bracket.
What’s the best way to change front brake pads?
Position a large c-clamp on the caliper and tighten the c-clamp down to push the piston back into its bore. Step 9: Lubricate the new brake pads. Apply disc brake grease to the back of the new pads to prevent brake noise.
How are brake pads secured to the caliper?
When installing brake pads on some vehicles the caliper retaining bolts will actually hold the pads in place. On these types of systems sometimes the factory will secure the caliper bolts with a thread locking compound to prevent them from backing out.