What size desoldering braid do I need?
#1 braid is the smallest at . 8 mm wide, but most will find #2 (1.5 mm), #3 (2 mm), and #4 (2.8 mm) to be the most commonly used. #5 is ideal for removing large blobs of solder, and #6 is best for desoldering BGA pads. Most find it helpful to keep three or four different widths at their work area.
What is desoldering braid used for?
Desoldering braid or “wick” is a pre-fluxed copper braid that is used to remove solder, which allows components to be replaced and excess solder (e.g. bridging) to be removed.
What is the solder braid wick covered with why?
rosin flux
Desoldering braid, also known as desoldering wick or solder wick, is finely braided 18 to 42 AWG copper wire coated with rosin flux, usually supplied on a roll. The end of a length of braid is placed over the soldered connections of a component being removed.
Is it necessary to use a soldering iron when desoldering?
Using the tip of the soldering iron will remove the copper plating from the PCB. Pros: You need nothing but a soldering iron, and the components can be reused. Cons: You may damage the board if you leave the soldering iron on it for too long.
Which is better desoldering pump or wick?
Both are effective can be used easily by anyone. Though for the most part, both methods can be used interchangeably, it is often advisable to use a desoldering pump to remove large amounts of solder and a desoldering wick to remove smaller amounts of solder like what is used to tack a wire to a board, for example.
What is D Sol Wik?
– Desol-wik consists of a copper wire braiding with excellent heat conducting properties. This is coated with a fine layer of soft chemicals which give it a long shelf life while playing a vital role in the desoldering process. Key features: – Easy to use, reduces thermal shock, – Non-corrosive protective residue.
Do you need a wick to Desolder?
Cleaning after using Techspray No-Clean wick is optional. Pro-Wick desoldering wick – coated with a fast activating rosin flux for lightning fast solder removal.
Which is the best way to desolder braid?
The temptation is to desolder an area and keep moving up the spool of braid. However, it’s best to work towards the end of the braid to isolate the heat. Once the desoldering wick is brought up to soldering temperature, the flux has been fully activated, so that part will not draw more solder.
Which is better solder wick or desoldering braid?
Desoldering braid (wick) is made of fine strands of ultra-pure copper woven and coated with flux. Its geometrically precise weave design allows for maximum capillary action and solder capacity. Soder-wick optimizes heat transfer through the braid and into the solder joint, resulting in faster wicking action than any other competitive brand.
Which is the best brand of Braid solder?
Soder-Wick, the world’s leading brand of desoldering braid (solder wick, desoldering wick) is the fastest, cleanest and safest braid in the industry. It significantly reduces rework/repair time and minimizes the risk of heat damage to the board. Its geometrically precise weave design allows for maximum capillary action and solder capacity.
Can a flux be added to a unfluxed braid?
Unfluxed – In a production or repair environment where the flux is specified and can’t be changed, or when an aqueous flux is needed, you can add your own flux to this type of braid. Unfluxed wick will not remove solder unless flux is added. Different types of fluxes are available in pen packaging, which is ideal for fluxing braid.