What should I do if my Mercedes injector is not working?
Once identified the work can begin – Run the engine until nice and warm then turn it off and remove the keys. Remove the turbo supply hose to the inlet manifold and split the composite intake manifold by removing the pins that secure it to the lower section.
How much does a 2002 Mercedes Benz ML cost?
Mercedes-Benz ML 320 4MATIC $5,000 Fox Auto Center Inc Used 2000 Mercedes-Benz ML 320 4MATIC $5,399 sandiegocarforsale.com Used 2002 Mercedes-Benz ML 500 4MATIC $5,950 Championship Motors at Bear Creek Used 2004 Mercedes-Benz ML 500 4MATIC $6,500 BMW MINI of Sterling Used 2003 Mercedes-Benz ML 350 4MATIC $7,495 Industry Motors Used 2003
Are there any problems with the Mercedes C320?
The Mercedes C-class coupes are luxury vehicles. Read more Mercedes-Benz reviews to learn about other models. Have a 2001 c320 Mercedes and having the same problems as others. Battery dies overnight, car ran out of gas on passenger side tank, 5 error on tail lights and so on.
How much does a Mercedes Benz ML 350 cost?
Mercedes-Benz ML 350 4MATIC $7,495 Industry Motors Used 2003 Mercedes-Benz ML 350 4MATIC $11,000 VW-BENZ Used 2003 Mercedes-Benz ML 350 4MATIC New Listing $13,995 Geneva Motorcars Used 2000 Mercedes-Benz ML 55 AMG 4MATIC $24,900 The Autobarn Volkswagen – Countryside 44 Mercedes-Benz M-Class vehicles for sale.
Why does my ML not start while driving?
One might be the cause of the battery drain or not starting then your ML may have lost the key information. If it wouldn’t start or it stop while driving but after say 30 minutes it would start and run normally then it might be your crank shaft position sensor. $50 sensor back of engine drivers side about 10 minutes to diy fix.
Can a pre 2000 ml lose its settings?
On the early pre 2000 ml’s the aam can loose it’s settings when disconnected from the battery. These can include the ignition key sync or even the keys rfid information. If when you try to start it starts then run some for maybe a half second before shutting down this could be your problem.
What happens if you turn off the Aam on a 2000 ml?
STARTS UP SHUTS DOWN BATTERY WENT DEAD CHANGE IT NOW IT WONT STAY RUNNING. It will if u keep it running for 10 minutes.. On the early pre 2000 ml’s the aam can loose it’s settings when disconnected from the battery. These can include the ignition key sync or even the keys rfid information.
What should I do if my Mercedes Benz won’t start?
Start the car and you should be able to get around 60 psi. When the engine is running and when you turn off the engine the pressure should stay steady. Always perform this test on a cold engine. Next, make sure that the fuel injector connections are secure and not loose. Check the fuel pump and the fuel pump relay.
What to use to clean Mercedes diesel injector seat?
Use a torch to inspect the injector seat in the cylinder head, it will likely be blackened and carbonised, this needs to be cleaned off and in severe cases re-cut to present a perfect sealing surface. I have in the past had great success using a wooden dowel, rather like the ones used on a valve grinding hand tool.
How much elongation does a Mercedes injector need?
Elongation was approx. 0.30mm for each increment of 90 degrees of tightening rotation (after the 62 in/lb initial torque). TRIAL 3-A fresh hold down bolt tightened to failure. The bolt tolerated several additional 90 degree sequences PAST the initial 62 in/lbs and 2×90 degrees.
What to do if you have a diesel injector problem?
Start the engine and watch for the darkening/spotting of the brown paper with diesel spray, this will indicate quite clearly where the problem lies. Once identified the work can begin – Run the engine until nice and warm then turn it off and remove the keys.
When to change the fuel injector in a car?
This is a critical rubber part that seals the fuel injector to the injector holder. Deterioration can result in high idle speeds and poor engine performance. Unless you have a low mileage car with soft seals, these should be changed when testing, cleaning, or replacing your fuel injectors. Brand new Bosch Fuel Injector as shown.
When did the Bosch fuel injectors come out?
Six new Bosch CIS fuel injectors with six holder bushing O-ring seals. If your 6 cylinder 103 engine has over 120,000 miles and you think your injectors are ok then you might want to think again. Brand new Bosch Fuel injector for most CIS engines built between 1977 to 1992. Bushing that holds fuel injector into the head of the engine.
Can a pressure tester be used to clean an injector?
A pressure tester such as the one we sell here can also be used to clean the internals of the injectors if they fail the initial pressure tests. In many cases, but not all, cleaning with pressure strokes and the proper cleaner can restore an injector to proper working condition.
What happens when you drill a hole in a Mercedes Sprinter?
Any solids in the hole will be compressed at the base of the drilling when the bolt is tightened and can cause cracking or worse – bursting through into the water jacket of the cylinder head (really easily done) so clean that hole with an air-line or blow gun until you are sure it’s clear.
How big is the injector seal ring on a Mercedes?
The extended threaded shank length, 85.83mm long, 6.0mm dia., 8.8 grade, factory hold down bolt, hold down pawl and injector seal ring are identical part numbers for both the 5 cyl. and 6 cyl. engines.