What should I do if my lift gate is not working?
Nothing happens when the liftgate is raised and I push the button to lower it from either the fob or the square button on the bottom of the gate itself. However, when I close the gate and press the button on the handle, I can hear the mechanism inside the gate working.
How to disable the power liftgate on a GM car?
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
What causes the rear liftgate to open and close?
For example – the rear liftgate opens and after motion occurs in one direction, the liftgate may reverse direction and close. The cause of this condition may be specific to the remote keyless entry (RKE) transmitter’s button configuration and the press and hold feature.
Is there a connection to the liftgate module?
Yes, there is a connection, I have seen a jump start blow out the setting in the liftgate module or sometimes even damage the lift gate module. I see. When the battery went dead, I didn’t have to reset the radio stations upon recharging it so it didn’t kill that type of thing.
Why is my rear lift gate not working?
The motor on my rear lift gate works, but liftgate won’t open: It starts to open and then closes itself. I cannot physically lift it. Is the problem with the hydrolics? It is not cold, frozen, it worked yesterday. The glass portion will open. Replaced glass release button a month ago. Exact problem happened to me days after I bought my 11 Denali.
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
What to do if your liftgate is not flush?
Perform the liftgate calibration procedure. 7 The liftgate may not be flush to the fascia. Move the striker rearward to flush out gate and relearn. Marking the current location of the liftgate striker, loosen the striker bolts and strike the striker rearward with a mallet to adjust the liftgate striker outboard (to the rear of the vehicle).
Yes, there is a connection, I have seen a jump start blow out the setting in the liftgate module or sometimes even damage the lift gate module. I see. When the battery went dead, I didn’t have to reset the radio stations upon recharging it so it didn’t kill that type of thing.