What should I do if my Clifford car alarm is not working?
The next alternative is to open the door with the key allowing the alarm to sound. Open the hood, disconnect the battery and unwire the alarm reverting to how it was before installing the alarm system. A new Clifford alarm kit can be ordered and the module swapped. The kit will come complete with two new remotes.
Why is my early 944 alarm module not working?
Early 944 Alarm Module – 911.637.104.00 Attempt to start the vehicle to verify that the alarm bypass was successful. If the jumpers were installed to troubleshoot a “no start” condition and the car still does not start, the alarm module is not the problem.
Where is the jumper on a late model 944?
On late model 944s, it’s located behind the kick panel in the passenger’s footwell near above the DME computer. Disconnect the electrical plug from the alarm module. Connect one jumper from Pin 1 to Pin 4 on the large module connector. Connect the second jumper from Pin 7 to Pin 8 on the large module connector.
Why does my car alarm keep going off?
The disarm relay which is the brains of the system has failed and will need to be replaced. The relay fails when in contact with water. It could be an alert to a sensor signal indicating that something is wrong. Ask an Expert for help to override the alarm so it does not keep going off when on the road.
Is there a way to disable the Clifford alarm system?
The Clifford alarm system is a popular security system for vehicles with features such as automatic engine disable, code hopping, passive arming and starter kill. Disabling a Clifford alarm system is a simple process that can be done in a matter of minutes.
Where is the valet button on a Clifford alarm?
Determine the location of the valet button in your vehicle. The valet button is installed in a discreet location in a vehicle. When the Clifford alarm system is installed, the installer generally provides the location and the number of times the button should be pressed.
Early 944 Alarm Module – 911.637.104.00 Attempt to start the vehicle to verify that the alarm bypass was successful. If the jumpers were installed to troubleshoot a “no start” condition and the car still does not start, the alarm module is not the problem.
What should I do if my car alarm keeps going off?
Disconnect the negative terminal (the black one) from your battery. The alarm should shut off immediately. Wait a minute or two and reconnect the battery. Hopefully, the alarm has reset and will not start up again.