What should I do about my 2015 Polaris Ranger 900?

2015 Polaris ranger 900 crew. replaced fuel pump 58 PSI on rail, replaced the starter, the unit cranks but will not start no matter what I do unless I use either than it cranks and runs fine. If it wa… read more Chris A-level motorcycle technician

Can you use the + 58 psi pump on Polaris Ranger 800?

This was something Polaris did to address hot fuel tank problems but didn’t really make a lot of noise about this change. This update can be made to 2011 and 2012 Ranger 800’s that are experiencing stalling and poor running in hot conditions. The 2013+ 58 psi pump can’t be used without having the ECU reflashed by a Polaris dealer.

Where can I buy a Polaris fuel pump?

This item: Fuel Pump with Regulator fits 2013-2019 Polaris Ranger 900 / XP / 4×4 / RAZR & 2013-2019 RZR 900… CDN$89.99 Only 8 left in stock. Sold by ERZ Industries LLC and ships from Amazon Fulfillment.

Can you put gas in a Polaris Ranger?

If I put a bit of gas in the injector wholes and put it all back together it will start and run on its own. Sit there and idle all day but when you drive it it will not tach up it will only do 10mph in low or high or reverse. Shut it off and no start again unless gas is introduced into injector ports.

Where is the fuel line on a Polaris Ranger?

Besides the “hot tank theory” the fuel line crosses the exhaust pipe very close, within four inches. Previous years equipped with EFI had run the fuel line along the top of the seat with adequate protection for the hose and away from heat (surprisingly had no vapor lock with 39 psi pumps).

What to do about fuel vapor lock on Polaris Ranger?

So far, to address fuel vapor lock problems on 2011 and 2012 Rangers, Polaris has this as an authorized fix for these older machines and at the dealer I work at, we have been able to cover the cost of repair to the customer by submitting it as an emissions warranty claim.

Navigation