What kind of wrench do I need to remove a transmission?
Wrenches Every mechanics tool set has a variety of wrenches suitable for removing a transmission. You should make sure that your tools include a collection of open-end and box-end wrenches, sockets, drivers, a breaker bar, and a good pair of vise grips to be used as a last resort.
What’s the best way to remove a transmission?
Begin with the vehicle lifted enough to access the transmission while using jack stands for safety, wear protective eyewear and gloves. Step 1 – Start by removing the negative battery cable end to help prevent electrical short circuits while the job is being done.
How do you remove cooler line from transmission?
Unscrew the fittings. Remove cooler line from transmission fitting. Pull the line out of the transmission fitting, taking care not to bend the line. The line is usually made of steel, ranging in width from 5/16-inch to 3/8-inch with a flare nut on the end. It can be up to 5 feet in length, but it depends on the type of car.
How do you replace a rear wheel drive transmission?
Easy to follow step by step guide on how to replace or remove an automotive manual (standard) transmission for rear wheel drive vehicles, though appearances may vary, the process is the same on most vehicles. Tools and Supplies Needed Hoist or hydraulic jack with stands.
How to remove automatic transmission from Jeep Cherokee?
Push the transmission over to the passenger side until the transfer case linkage comes free which will cause the whole unit to drop even farther. Disconnect electrical connections, breather lines, sensors, and shift linkages from the top of the transmission.
Which is cooler line for Jeep Cherokee transmission?
Shop AutoZone for Jeep Cherokee Transmission Cooler Line Assembly. Notes: Auxiliary cooler outlet (upper) to transmission (rear).
Wrenches Every mechanics tool set has a variety of wrenches suitable for removing a transmission. You should make sure that your tools include a collection of open-end and box-end wrenches, sockets, drivers, a breaker bar, and a good pair of vise grips to be used as a last resort.
Unscrew the fittings. Remove cooler line from transmission fitting. Pull the line out of the transmission fitting, taking care not to bend the line. The line is usually made of steel, ranging in width from 5/16-inch to 3/8-inch with a flare nut on the end. It can be up to 5 feet in length, but it depends on the type of car.